Signode Corporation v. Weld-Loc Systems, Inc. And Strapex Ag

700 F.2d 1108, 218 U.S.P.Q. (BNA) 293, 1983 U.S. App. LEXIS 30238
CourtCourt of Appeals for the Seventh Circuit
DecidedFebruary 23, 1983
Docket82-2025
StatusPublished
Cited by40 cases

This text of 700 F.2d 1108 (Signode Corporation v. Weld-Loc Systems, Inc. And Strapex Ag) is published on Counsel Stack Legal Research, covering Court of Appeals for the Seventh Circuit primary law. Counsel Stack provides free access to over 12 million legal documents including statutes, case law, regulations, and constitutions.

Bluebook
Signode Corporation v. Weld-Loc Systems, Inc. And Strapex Ag, 700 F.2d 1108, 218 U.S.P.Q. (BNA) 293, 1983 U.S. App. LEXIS 30238 (7th Cir. 1983).

Opinion

ESCHBACH, Circuit Judge.

Signode Corporation (“Signode”) appeals from the district court’s denial of its motion for a preliminary injunction in a patent infringement case. For the reasons below, we affirm.

I

Signode has been manufacturing tools for friction welding plastic strapping since *1110 1966. Signode is the owner of United States Patent Nos. 3,442,732 and 3,442,735, issued in 1969, which define the friction weld process and the apparatuses used in the process. The process, known as “Tension-Weld,” involves overlapping the ends of plastic strapping, forcing the ends together under pressure while moving them against each other to cause the plastic to become molten, then ceasing the movement to allow the plastic to re-solidify, forming a joint between the two ends. This process is accomplished by hand tools, one of which Signode sells for approximately $985.00. Signode also sells unpatented plastic tape for use with its tools. •

Appellee Weld-Loc Systems, Inc. (“WeldLoc”) is an Ohio corporation with 900 shares of stock outstanding. Appellee Strapex AG owns 500 of these shares. Strapex AG, a Swiss corporation, manufactures a hand tool for friction welding plastic strips known as the Strapex Model 361 Vibratory Sealing Tool (“Strapex Model 361”). Strapex AG was selling the Model 361 in Europe as early as 1976 or 1977. In 1976, Richard A. Wolschlag, President of Weld-Loc, asked Signode for a license under one of its patents so that Weld-Loc could sell the Strapex Model 361 in the United States. Signode refused to grant a license.

In September 1980, Strapex Corporation, a wholly owned subsidiary of Appellee Weld-Loc, began marketing the Strapex Model 361 in the United States. Signode became aware of this shortly thereafter. At the time of the hearing before the magistrate, Weld-Loc, itself or through Strapex Corporation, had sold three to four hundred of these tools for a price of approximately $1,350.00 each.

Signode brought a patent infringement suit against Strapex Corporation in May 1981 in Florida. In December 1981, Signode brought this suit against Weld-Loc and Strapex AG in the Northern District of Illinois, charging patent infringement, and moved for a preliminary injunction. With the consent of both parties, the motion was referred to a magistrate, according to 28 U.S.C. 636(b)(1). The magistrate conducted an evidentiary hearing, submitted proposed findings of fact and conclusions of law, and recommended that the preliminary injunction be denied because of Signode’s failure to establish irreparable harm. The district court adopted the magistrate’s Report and Recommendations and denied Signode’s motion for a preliminary injunction. Signode appeals.

II

Signode raises several issues on appeal. First, Signode contends that the district court erred in failing to make a de novo determination of the portions of the magistrate’s report to which objections were made. Signode next asserts that the magistrate and the district court erred in concluding that Signode had not established irreparable harm. Signode argues that irreparable harm would occur in the absence of a preliminary injunction because WeldLoc and Strapex AG would be financially unable to respond in damages if their activities are allowed to continue until trial on the merits and because Signode would be forced to bring a multitude of suits against the would-be customers of Weld-Loc and Strapex AG to enjoin all of them from using Signode’s patented process. 1

III

A. The Necessity of a De Novo Determination

Under 28 U.S.C. 636(b)(1), a district court judge may refer certain pretrial matters to a magistrate for a determination that will be reconsidered only if the magistrate’s order is clearly erroneous or contrary to law. Other matters, including motions for in *1111 junctive relief, can be referred to the magistrate for a determination that will be subject to de novo determination. The district judge is required to make a determination of any portion of the magistrate’s findings or recommendations to which objection is made. Both parties correctly recognize that Signode’s motion for a preliminary injunction was subject to the district court’s de novo review. There is nothing in the record to indicate that Signode waived a de novo determination.

In its opinion, the district court stated that the magistrate’s findings of fact were not clearly erroneous, but then proceeded to set out what appears to be its own findings of fact, made after a “careful review of the record.” We therefore cannot state with certainty which standard of review the district court was applying. However, the determination of the propriety of a preliminary injunction in this case depends entirely on the resolution of legal issues. The facts regarding the appellees’ financial condition are not seriously disputed; and, as will become apparent, resolving all the other factual issues in favor of Signode still does not establish irreparable harm if the legal issues are decided in favor of the appellees. Because the resolution of the legal issues dictates denial of the preliminary injunction on the record before us, 2 the standard of review that the district court used to review the magistrate’s factual determinations, if incorrect, would not affect our affirmance of the denial.

B. The Prerequisites of Preliminary Injunctive Relief

A court’s discretion in granting or denying preliminary injunctive relief must be guided by consideration of four factors: whether the plaintiff will be irreparably harmed in the absence of a preliminary injunction, whether the threatened injury to the plaintiff outweighs the harm an injunction may inflict on the defendant, whether the plaintiff has at least a reasonable likelihood of success on the merits, and whether granting a preliminary injunction will disserve the public interest. O’Conner v. Board of Education, 645 F.2d 578, 580 (7th Cir.), cert denied, 454 U.S. 1084, 102 S.Ct. 641, 70 L.Ed.2d 619 (1981); Fox Valley Harvestore v. A.O. Smith Harvestore Products, Inc., 545 F.2d 1096,1097 (7th Cir.1976). A preliminary injunction is an extraordinary remedy, available only to plaintiffs who carry the burden of persuasion as to all four factors. Id. at 1097. As a general rule, “a defendant’s ability to compensate plaintiff in money damages precludes issuance of a preliminary injunction.” Nuclear-Chicago Corp. v. Nuclear Data, Inc., 465 F.2d 428, 430 (7th Cir.1972); see. also Sinko Tool & Mfg. Co. v. Casco Products Corp., 89 F.2d 916, 921 (7th Cir.1937); Artmoore Co. v. Dayless Mfg. Co.,

Free access — add to your briefcase to read the full text and ask questions with AI

Related

Cite This Page — Counsel Stack

Bluebook (online)
700 F.2d 1108, 218 U.S.P.Q. (BNA) 293, 1983 U.S. App. LEXIS 30238, Counsel Stack Legal Research, https://law.counselstack.com/opinion/signode-corporation-v-weld-loc-systems-inc-and-strapex-ag-ca7-1983.