Beyer v. Anchor Insulation Co.

238 F. Supp. 3d 270, 2017 U.S. Dist. LEXIS 23434, 2017 WL 1250984
CourtDistrict Court, D. Connecticut
DecidedFebruary 17, 2017
DocketCivil No. 3:13-cv-1576 (JBA)
StatusPublished
Cited by4 cases

This text of 238 F. Supp. 3d 270 (Beyer v. Anchor Insulation Co.) is published on Counsel Stack Legal Research, covering District Court, D. Connecticut primary law. Counsel Stack provides free access to over 12 million legal documents including statutes, case law, regulations, and constitutions.

Bluebook
Beyer v. Anchor Insulation Co., 238 F. Supp. 3d 270, 2017 U.S. Dist. LEXIS 23434, 2017 WL 1250984 (D. Conn. 2017).

Opinion

RULING ON DEFENDANT’S MOTION FOR SUMMARY JUDGMENT

Janet Bond Arterton, United States District Judge.

Defendant Anchor Insulation Co. (“Anchor” or “Defendant”) moves [Doc. # 189] for summary judgment on all remaining counts in this product liability action involving Defendant’s installation of spray polyurethane foam insulation (“SPF”) in the home of the Plaintiffs Richard and Monica Beyer (“Plaintiffs” or the “Bey-ers”), arguing that Plaintiffs cannot establish product defect or causation absent expert testimony that must be precluded as argued in Defendant’s three separate Dau-bert motions [Docs. ## 192 (Motion to preclude Testimony of Mr, Gary Cude), 194 (Motion to Preclude Testimony of Dr. Yuh-Chin Huang), and 195 (Motion to Preclude Testimony of Dr. David Nicewicz).1 [274]*274Oral argument was held on January 17, 2017. For the reasons set out below, the Court GRANTS Defendant’s motion to preclude the testimony of Dr. Yuh-Chin Huang, GRANTS in part and DENIES in part Defendant’s motion to preclude the testimony of Mr. Gary Cude (limiting his testimony to his areas of expertise) and GRANTS in part and DENIES in part Defendant’s motion to preclude the testimony of Dr. David Nicewicz (limiting his testimony to his areas of expertise). Based on these Daubert rulings, the Court DENIES Defendant’s motion for summary judgment.

1. Background2

A. SPF Foam Insulation

The SPF at issue in this case is a foam insulation that forms when two liquids, an isocyanate component and a polyol resin component, referred to as “A Side” and “B Side,” come together at the tip of a spray gun in equal parts. (See Plaintiffs Memorandum in Opposition to Mot. Summ. J. (“Mem. Opp’n”) [Doc. # 225] at 3; Ex. 28 (“John Mansville Corbond III Advertisement”) to Opposition to Summ. J. (“Opp’n”) [Doc. #228-30] at 1.) The A Side and B Side are stored in separate drums, pumped through separate hoses and combined at nozzle-point to spray onto surfaces that are to be insulated. (Corbond III Advertisement at 3.) When the two sides combine, they form a foam that expands and goes through a period of curing before it is a fully finished product. (Id.)

The spray foams at issue in this case are manufactured by Johns Manville (“JM”), which manufactures “Corbond III,” a 2 lb. “closed cell” spray foam insulation (Cor-bond III Advertisement at 3), and by Icyn-ene, which manufactures a 2 lb. spray foam insulation called “LD-R-50.” (Ex. 18 (“Icynene Technical Bulletin”) to Mem. Opp’n [Doc. # 225-20] at 2.) These companies are no longer in this case.

Both Johns Manville and Icynene train installers in the proper technique for installing spray foam, including installers from Anchor. (Plaintiffs’ D. Conn. L. Civ. R. 56a(2) Statement (“56a(2)”) [Doc. # 225-2] at ¶ 16). Both companies direct installers not to mix their product with that of other manufacturers. John Mans-ville notes that when SPF “is installed off ratio [i.e. when the A Side and B Side are not combined in equal parts], outside the manufacturer’s installation guidelines, or in concert with other products [e.g. when a Johns Manville A Side is mixed with an Icynene B Side or vice versa] which may affect the chemistry of the SPF product ... the resulting finished SPF product may shrink substantially and/or have sections of un-reacted or very brittle foam.” (Ex. 4 to Opp’n to Mot. Summ. J. [Doc. # 225-6].)

Anchor’s email correspondence with Icynene reflects similar beliefs about the [275]*275effects of mixing different products, though in more prosaic language. On December 21, 2011, Greg Fiske of Anchor wrote to Paul Duffy of Icynene regarding “Franken-foam:” “What I want to know is, if there was a contamination of Icynene into Corbond, is there a chance the result [ ] ... would be any more harmful than the sum of the parts? ... 90 + percent Corbond with a bit of Icynene, have we got some monster chemical that is deadly?” Paul Duffy forwarded the inquiry to Larry Genyn, the Vice President of Technology at Icynene, who responded, “there is no hybrid chemical that can be produced .... Even the bad foam that was there, may have had a distinct odor or feel, but nothing that would be classified as poisonous or toxic.” (Ex. 22 to Plaintiffs Opp’n to Mot. Summ. J. [Doc. #225-24].)

Johns Manville publishes Materials Safety Data Sheets (“MSDSs”) for its A Side, B Side, and the compound SPF foam. (Ex. 12 (“JM MSDSs”) to Opp’n. to Mot. Summ. J. [Doc. # 225-14].) The JM MSDS for A Side states that “breathing vapors from this product may cause irritation of the upper respiratory tract, fatigue, weakness, drowsiness, and headache. Allergic or asthma-type reactions may occur following sensitization to isocyanates.” (Id.) The MSDS for B Side indicates that “[i]nhalation at levels above the occupational safety exposure limit could cause respiratory sensitization and risk of serious damage to the respiratory system. The onset of respiratory symptoms may be delayed for several hours after exposure.” (Id.) By contrast, the finished spray foam is relatively inert, but nonetheless can be hazardous under certain conditions, primarily if ground into dust or chipped: “Primary routes of exposure: Respiratory tract if product is torn, chipped or ground into chips or dust. Mechanical irritant. Acute Effects: Inhalation: Repeated excessive exposure to dust or small chips may cause upper respiratory irritation.” (Id.)

Icynene’s president and CEO distributed a memorandum to all of its licensed dealers and distributors world-wide delineating safety procedures for installing Icynene foam. In its introduction, the memorandum stated,

[d]uring the handling, processing and application of Icynene spray foam products, exposure to chemicals, particularly MDI [methylene diphenyl diisocyanate], may cause a range of adverse health effects including irritation or sensitization. Short or long-term exposure to MDI can affect the skin, eyes and respiratory system. Chronic skin exposure can lead to skin irritation and/or sensitization, and may cause respiratory sensitization.

(Icynene Technical Bulletin at 1.)

B. Installation of the Foam

Plaintiffs Richard and Monica Beyer live in a century-old home in Niantic, Connecticut. Since 2000, Mr. Beyer has worked for a granite countertop company in a building that has been shared since 2009 with Defendant Anchor Insulation. Anchor used the warehouse to store its chemicals and in 2010 those chemicals were moved closer to Mr. Beyer’s work station. (See Ex. 17 (“Russomanno Report”) to Opp’n to Mot. Summ. J. [Doc. # 225-19] at 2-4.)

In Fall 2010, Plaintiffs contracted with Anchor' for the installation of SPF throughout their home. (Opp’n. to Mot. Summ. J. at 3.) Plaintiffs remained in the home during the installation, which took place on several days spaced out over some weeks in September and October 2010. Mr. Beyer personally observed some portion of the installation, while Mrs. Beyer was simply in the home during the installation. (56a(2) Stmt. ¶ 2.)3 Neither [276]*276Mr. Beyer nor the men installing the foam wore protective clothing, and Mr. Beyer did not wear any respiratory protective device.4 (Ex. 7 (“M. Beyer Tr.”) to Opp’n to Mpt. Summ. J. [Doc. # 225-9] at 41:8-21.)'

After the SPF was installed,- Plaintiffs noticed a sweet odor throughout their house (Ex.

Free access — add to your briefcase to read the full text and ask questions with AI

Related

Byrd v. Janssen Pharm., Inc.
333 F. Supp. 3d 111 (N.D. New York, 2018)

Cite This Page — Counsel Stack

Bluebook (online)
238 F. Supp. 3d 270, 2017 U.S. Dist. LEXIS 23434, 2017 WL 1250984, Counsel Stack Legal Research, https://law.counselstack.com/opinion/beyer-v-anchor-insulation-co-ctd-2017.