Montana § 61-9-210 Mounting Of Reflectors, Clearance Lamps, And Side Marker Lamps

Montana Statutes

§ 61-9-210 — Mounting Of Reflectors, Clearance Lamps, And Side Marker Lamps

Montana § 61-9-210

Title 61MOTOR VEHICLES

Ch. 9VEHICLE EQUIPMENT

Part 2Lighting Equipment

This text of Montana § 61-9-210 (Mounting Of Reflectors, Clearance Lamps, And Side Marker Lamps) is published on Counsel Stack Legal Research, covering Montana primary law. Counsel Stack provides free access to over 12 million legal documents including statutes, case law, regulations, and constitutions.

Bluebook

Mont. Code Ann. § 61-9-210 (2026).

Text

61-9-210 . Mounting of reflectors, clearance lamps, and side marker lamps.

(1)Reflectors when required by 61-9-208 shall be mounted at a height not less than 24 inches and not higher than 60 inches above the ground on which the vehicle stands, except that if the highest part of the permanent structure of the vehicle is less than 24 inches the reflector at such point shall be mounted as high as that part of the permanent structure will permit.

(2)The rear reflectors on a pole trailer may be mounted on each side of the bolster or load.

(3)Any required red reflector on the rear of a vehicle may be incorporated with the taillamp, but such reflector shall meet all the other reflector requirements of this chapter.

(4)Clearance lamps shall be mounted on the permanent structure of the vehicle

Free access — add to your briefcase to read the full text and ask questions with AI

61-9-210 . Mounting of reflectors, clearance lamps, and side marker lamps. (1) Reflectors when required by 61-9-208 shall be mounted at a height not less than 24 inches and not higher than 60 inches above the ground on which the vehicle stands, except that if the highest part of the permanent structure of the vehicle is less than 24 inches the reflector at such point shall be mounted as high as that part of the permanent structure will permit.
(2) The rear reflectors on a pole trailer may be mounted on each side of the bolster or load.
(3) Any required red reflector on the rear of a vehicle may be incorporated with the taillamp, but such reflector shall meet all the other reflector requirements of this chapter.
(4) Clearance lamps shall be mounted on the permanent structure of the vehicle in such a manner as to indicate its extreme width and as near the top thereof as practicable. Clearance lamps and side marker lamps may be mounted in combination provided illumination is given as required herein with reference to both.