§ 13-19-3-7 — Use of foundry sand

The department and the board shall allow a
person to use foundry sand that meets Type III criteria under 329 IAC
10-9 for the following activities in accordance with guidance without
requiring the person to obtain any permits from the department:
(1) As a daily cover for litter and vermin control at a landfill in
accordance with any applicable permits issued for the landfill.
(2) As a protective cover for a landfill leachate system in
accordance with any applicable permits issued for the landfill.
(3) For use as capped embankments for ground and sight barriers
under ten thousand (10,000) cubic yards or embankments for
airports, bridges, or overpasses.
(4) For use:
(A) in a land application operation; or
(B) as a soil amendment;
if the application or amendment does not include the operation of
a landfill.
(5) As a structural fill base capped by clay, asphalt, or concrete
for the following:
(A) Roads.
(B) Road shoulders.
(C) Parking lots.
(D) Floor slabs.
(E) Utility trenches.
(F) Bridge abutments.
(G) Tanks and vaults.
(H) Construction or architectural fill.
(I) Other similar uses.
(6) As a raw material constituent incorporated into another
product, including the following:
(A) Flowable fill.
(B) Concrete.
(C) Asphalt.
(D) Brick.
(E) Block.
(F) Portland cement.
(G) Glass.
(H) Roofing materials.
(I) Rock wool.
(J) Plastics.
(K) Fiberglass.
(L) Mineral wool.
(M) Lightweight aggregate.
(N) Paint.
(O) Plaster.
(P) Other similar products.

Legislative History

As added by P.L.129-1997, SEC.2. Amended by P.L.30-1999, SEC.3; P.L.14-2000, SEC.37; P.L.133-2012, SEC.133.