USX Corp. v. United States

655 F. Supp. 487, 11 Ct. Int'l Trade 82, 11 C.I.T. 82, 1987 Ct. Intl. Trade LEXIS 16
CourtUnited States Court of International Trade
DecidedFebruary 9, 1987
DocketCourt 85-03-00325
StatusPublished
Cited by67 cases

This text of 655 F. Supp. 487 (USX Corp. v. United States) is published on Counsel Stack Legal Research, covering United States Court of International Trade primary law. Counsel Stack provides free access to over 12 million legal documents including statutes, case law, regulations, and constitutions.

Bluebook
USX Corp. v. United States, 655 F. Supp. 487, 11 Ct. Int'l Trade 82, 11 C.I.T. 82, 1987 Ct. Intl. Trade LEXIS 16 (cit 1987).

Opinion

OPINION AND ORDER

RESTANI, Judge:

Plaintiff initiated this action to challenge a final negative determination of the International Trade Commission (ITC) regarding cold-rolled carbon steel plates and sheets from Argentina. 1 After finding that the U.S. cold-rolled carbon steel plate and sheet industry continues to be materially injured, ITC concluded that such injury was not by reason of Less Than Fair Value (LTFV) imports from Argentina. ITC also determined that LTFV imports from Argentina presented no threat of material injury. Plaintiff argues that these findings were in error for several reasons: 1) ITC failed to evaluate the significance of the volume of LTFV imports from Argentina; 2) ITC improperly based its negative determination on a finding of no confirmed instances of lost sales or revenue; 3) ITC failed to cu-mulate Argentine imports with those from several other countries; and 4) ITC’s negative determination with respect to threat of material injury was based on stale data regarding capacity utilization in the Argentine steel industry. These contentions are addressed below, following a brief discussion of the factual background of the case.

Facts

Plaintiff filed its administrative petition with the United States Department of Commerce, International Trade Administration (ITA) and ITC on February 10,1984. In its petition plaintiff alleged that cold-rolled sheet from Argentina was being sold, or was likely to be sold, in the United States at LTFV and, further, that such imports were a cause of material injury, or a threat thereof, to the corresponding domestic industry.

Following an affirmative preliminary material injury determination by ITC on March 26, 1984, ITA issued a preliminary determination that Argentine cold-rolled sheet was, or was likely to be sold in the United States at LTFV. 2 As a result of its determination, ITA ordered a suspension of liquidation with respect to all cold-rolled sheet from Argentina entered, or with *489 drawn from warehouse for consumption, on or after July 25, 1984.

In its final determination, ITA found that 100% of Argentine cold-rolled sheet was being sold in the United States at less than fair value. Weighted average dumping margins were 242.5% and 30.3% for two specific producers, and 122.3% for all others. 49 Fed.Reg. 48588, 48591 (1984). ITC subsequently initiated its final investigation, which disclosed the following facts.

The volume of Argentine cold-rolled steel imports rose constantly during the period under review, from zero tons in 1981, to 130,000 tons in 1983. During the first nine months of 1984, when liquidation of these imports was suspended, 116,000 tons were imported, which represented a 26% increase over the volume imported during the first three quarters of 1983. Following the initial introduction of Argentine cold-rolled steel into the U.S. market in 1982, levels of market penetration by Argentine imports remained fairly constant in the years reviewed by the investigation, fluctuating between .8% and .9% of the U.S. market.

The U.S. cold-rolled steel industry was mired in a recession when Argentine imports first entered the market in 1982. That year nine U.S. firms reported operating losses and the U.S. industry experienced an overall loss of $371 million. By the end of the investigatory period in 1984, the industry had shown some improvement. Shipments, capacity utilization, and employee hours had all increased by roughly 25% as compared with the industry’s most depressed period in 1982. Prices of several products examined by ITC also showed increases of 10-12% from the deepest stages of the industry recession to September 1984.

Despite these gains, in September 1984 the industry still lagged behind 1981 levels in shipments and employee hours, and showed an overall loss of $43 million. Prices of domestic steel products, though higher than prices during the industry recession, were only slightly higher than pre-recession prices in 1982. These facts led ITC to conclude that the U.S. industry continued to be materially injured, but not by reason of LTFV imports from Argentina.

Determination of No Injury by Reason of LTFV Imports from Argentina

In reviewing this determination, the court must grant a proper level of deference to ITC. The views of this court may not be freely substituted for those of ITC; nor may reversal be predicated solely on an interpretation of the facts that seems more reasonable. Only if ITC’s determination is not supported by substantial evidence, or if it was reached in a manner contrary to law, may it be overturned.

ITC is required to consider three factors when examining the causal connection between imports and material injury: 1) the volume of imports, 2) the effect of imports on prices of like domestic products, and 3) the impact of imports on domestic producers of like products. 19 U.S.C. § 1677(7)(B) (1982). ITC presented its brief discussion of these factors as follows. First, ITC noted that although imports from Argentina rose consistently from 1981 to 1984; only “minimal market penetration” was achieved throughout the period of the investigation. ITC Determination at 6. Second, ITC found that while Argentine im-porte undersold domestic cold-rolled sheets by margins ranging from 5% to 14%, it could not confirm any actual instances of lost sales and revenue due to Argentine imports. Id.

In light of the facte of this case, and relevant administrative and judicial precedent, this analysis must be rejected. Under the “substantial evidence” standard of review, the court must determine whether ITC’s conclusions are supported by the evidence on the record as a whole. SSIH Equip. S.A. v. United States Int’l. Trade Comm’n., 718 F.2d 365, 382 (Fed.Cir.1983) (additional comments of Circuit Judge Nies, quoting from Universal Camera Corp. v. NLRB, 340 U.S. 474, 477, 488, 71 S.Ct. 456, 459, 464, 95 L.Ed. 456 (1951)). ITC may not rely upon isolated tidbits of data which suggest a result contrary to the clear weight of the evidence. In this case, the reasons presented by a majority of the commissioners, without further elabora *490 tion, cannot reasonably be said to support the result reached.

In its discussion of import volume, ITC focused exclusively on the level of market penetration achieved by Argentine imports. ITC’s analysis of market penetration data consisted solely of the statement that levels of market penetration remained low and stable. 3 Without discussing the significance of this trend or its relationship to other facts uncovered in the investigation, ITC then stated its bald conclusion that the U.S. industry had not been materially injured by reason of Argentine imports. The court has noted that “Congress has not only directed ITC to state its determinations but has also required the agency to explain

Free access — add to your briefcase to read the full text and ask questions with AI

Related

Tenaris Bay City, Inc. v. United States
2025 CIT 78 (Court of International Trade, 2025)
Cleveland-Cliffs Inc. v. United States
693 F. Supp. 3d 1341 (Court of International Trade, 2024)
DAK Americas LLC v. United StatesPublic version posted 06/04/2020.
456 F. Supp. 3d 1340 (Court of International Trade, 2020)
Maverick Tube Corp. v. United States
273 F. Supp. 3d 1293 (Court of International Trade, 2017)
Shandong Rongxin Import & Export Co. v. United States
163 F. Supp. 3d 1249 (Court of International Trade, 2016)
JMC Steel Group v. United States
24 F. Supp. 3d 1290 (Court of International Trade, 2014)
CP Kelco US, Inc. v. United States
24 F. Supp. 3d 1337 (Court of International Trade, 2014)
Swiff-Train Co. v. United States
904 F. Supp. 2d 1336 (Court of International Trade, 2013)
Gold East Paper (JIANGSU) Co. v. United States
896 F. Supp. 2d 1242 (Court of International Trade, 2012)
A.L. Patterson, Inc. v. United States
2012 CIT 103 (Court of International Trade, 2012)
Nucor Corp. v. United States
605 F. Supp. 2d 1361 (Court of International Trade, 2009)
Nucor Corp. v. United StatesPublic version posted on 03/24/09
2009 CIT 16 (Court of International Trade, 2009)
Elkem Metals Co. v. United States
32 Ct. Int'l Trade 938 (Court of International Trade, 2008)
Diamond Sawblades Manufacturers Coalition v. United States
32 Ct. Int'l Trade 134 (Court of International Trade, 2008)
Wieland Werke, AG v. United States
525 F. Supp. 2d 1353 (Court of International Trade, 2007)
Nevinnomysskiy Azot v. United States
31 Ct. Int'l Trade 1373 (Court of International Trade, 2007)
Cleo, Inc. v. United State
30 Ct. Int'l Trade 1380 (Court of International Trade, 2006)
Hynix Semiconductor, Inc. v. United States
431 F. Supp. 2d 1302 (Court of International Trade, 2006)
Nippon Steel Corp. v. United States
350 F. Supp. 2d 1186 (Court of International Trade, 2004)
Committee for Fair Coke Trade v. United States
28 Ct. Int'l Trade 1140 (Court of International Trade, 2004)

Cite This Page — Counsel Stack

Bluebook (online)
655 F. Supp. 487, 11 Ct. Int'l Trade 82, 11 C.I.T. 82, 1987 Ct. Intl. Trade LEXIS 16, Counsel Stack Legal Research, https://law.counselstack.com/opinion/usx-corp-v-united-states-cit-1987.