Sekisui America Corp. v. Hart

15 F. Supp. 3d 359, 2014 U.S. Dist. LEXIS 22998, 2014 WL 687222
CourtDistrict Court, S.D. New York
DecidedFebruary 21, 2014
DocketNo. 12 Civ. 3479(SAS)
StatusPublished
Cited by7 cases

This text of 15 F. Supp. 3d 359 (Sekisui America Corp. v. Hart) is published on Counsel Stack Legal Research, covering District Court, S.D. New York primary law. Counsel Stack provides free access to over 12 million legal documents including statutes, case law, regulations, and constitutions.

Bluebook
Sekisui America Corp. v. Hart, 15 F. Supp. 3d 359, 2014 U.S. Dist. LEXIS 22998, 2014 WL 687222 (S.D.N.Y. 2014).

Opinion

OPINION AND ORDER

SHIRA A. SCHEINDLIN, District Judge.

I. INTRODUCTION

Sekisui America Corporation (“SAC”) and Sekisui Medical Co., Ltd. (“SMD”) (collectively, “Sekisui”) bring this action for breach of contract against Richard Hart and Marie Louise Trudel-Hart (the “Harts”).1 Sekisui alleges that the Harts [362]*362breached representations and warranties set forth in Sections 4.12, 4.14(a), 4.14(c), and 4.14(d) of the parties’ Stock Purchase Agreement (“SPA”). The Harts’ alleged breaches fall into two categories: (1) breaches related to the failure of America Diagnostica, Inc. (“ADI”) to comply with FDA regulations, known as Quality System Regulations (“QSRs”); and (2) breaches related to Femtelle, ADI’s breast cancer prognosis assay.2 The Harts deny that they breached any provision of the SPA and counterclaim that Sekisui breached Section 2.6(d) by failing to use commercially reasonable efforts to market Femtelle and omitting to take actions to obtain FDA approval for Femtelle, thereby preventing ADI from maximizing Femtelle revenues.3 Both parties seek damages.

I held a bench trial from January 18 to January 17, 2014. The parties made post-trial submissions on January 31, 2014. Pursuant to Rule 52(a) of the Federal Rules of Civil Procedure, I make the following findings of fact and conclusions of law. In reaching these findings and conclusions, I heard the testimony, examined the documentary evidence, observed the demeanor of the witnesses, and considered the arguments and submissions of counsel.

II. FINDINGS OF FACT

A. Background

1. The Parties

In 1982, the Harts founded ADI, a Connecticut corporation engaged in the discovery, manufacture, and marketing of medical diagnostic products.4 ADI manufactured and marketed products that were designated “Research Use Only” and products that could be used as in vitro diagnostics (“IVD”).5 ADI was the parent company of a Canadian subsidiary, a German subsidiary, and a French subsidiary.6 ADI with its subsidiaries had a maximum of thirty-five employees.7

The Harts are citizens and residents of Connecticut.8 Until Sekisui acquired ADI, the Harts owned 95.94% of the existing and outstanding shares of common stock of ADI.9 Richard Hart served as the President and Chief Executive Officer (“CEO”) of ADI and oversaw the company’s operations.10 Hart left ADI in April 2010 for medical reasons.11

SAC and SMD are wholly owned subsidiaries of Sekisui Chemical Co., Ltd.12 SAC is a corporation organized under Delaware law with its principal place of business in New Jersey.13 SMD is a Japanese corporation with its principal place of business [363]*363in Tokyo.14 Sekisui engages in the research, development, manufacture, sale, import, and export of plastic medical products.15

2. FDA Regulations and Procedures

Section 520(f) of the Food Drug & Cosmetic Act (the “Act”) gives the FDA authority to prescribe regulations requiring that the methods, facilities, and controls used for the manufacture, packing, storage, and installation of medical devices conform to good manufacturing practices.16 In 1997, the FDA promulgated the QSRs.17 Under the QSRs, medical device manufacturers should “establish and maintain a quality system that is appropriate for the specific medical device(s) designed or manufactured, and that meets the requirements of’ the QSRs.18 Failure to comply with the QSRs renders a device “adulterated” under the Act.19

The QSRs are flexible regulations. According to the FDA, the QSRs are “an umbrella ... that specifies general objectives rather than methods.”20 Because the QSRs “must apply to so many different types of devices, the regulation does not prescribe in detail how a manufacturer must produce a specific device.”21 Instead, “the regulation provides the framework that all manufacturers must follow by requiring that manufacturers develop and follow procedures and fill in the details that are appropriate to a given device ....”22

The FDA advises its inspectors to “use good judgment in determining compliance with the [QSRs], keeping in mind that it is an umbrella ... and all requirements may not apply or be necessary.”23 Furthermore, inspectors should “not insist that a manufacturer meet non-applicable requirements.” 24 Inspectors should recognize that at small firms “division of work is at a minimum, with one person often assembling and testing the finished device.”25 As such, “blueprints or engineering drawings could be adequate procedures,” and “several requirements can be met with a single procedure.”26

To determine compliance with the QSRs, the FDA conducts an Establishment Inspection (“El”).27 An El is an inspection of a medical device manufacturing firm’s facilities and records.28 During an El, the inspector interviews the firm’s management responsible for the QMS.29 Inspec[364]*364tors use a “top-down” approach to evaluate a firm’s system for addressing quality in four main areas: Management Control, Corrective and Preventive Actions (“CAPA”), Design Controls, and Production and Process Controls.30 Nonconform-ities must be addressed through the CAPA process.31 CAPAs come from a company’s own monitoring process, regulatory inspections, customer audits, and internal audits.32

After the El, the inspector may issue a Form 483, which may include “inspeetional observations.”33 Inspeetional observations are not “final [FDA] determinationfs] regarding [a firm’s] compliance.”34 Moreover, inspectors must not report opinions, conclusions, or conditions as “violative” because “[t]he determination of whether any condition is violative is an agency decision made after considering all circumstances, facts and evidence, involving discussions with management....”35 The inspector then discusses the Form 483 with the manufacturer’s senior management.36 The firm may respond at that time or send a corrective action plan to the FDA shortly thereafter.37

The Director of the relevant field office considers the Form 483 observations, the inspector’s narrative of the inspection — the Establishment Inspection Report (“EIR”) — and the firm’s responses to the Form 483 observations.38 The Director then classifies the inspection as no action indicated (“NAI”), voluntary action indicated (“VAI”), or official action indicated (“OAI”).39

Free access — add to your briefcase to read the full text and ask questions with AI

Related

Cite This Page — Counsel Stack

Bluebook (online)
15 F. Supp. 3d 359, 2014 U.S. Dist. LEXIS 22998, 2014 WL 687222, Counsel Stack Legal Research, https://law.counselstack.com/opinion/sekisui-america-corp-v-hart-nysd-2014.