Kaiser Aluminum & Chemical Corporation v. Federal Trade Commission

652 F.2d 1324, 1981 U.S. App. LEXIS 11691
CourtCourt of Appeals for the Seventh Circuit
DecidedJuly 7, 1981
Docket79-1886
StatusPublished
Cited by47 cases

This text of 652 F.2d 1324 (Kaiser Aluminum & Chemical Corporation v. Federal Trade Commission) is published on Counsel Stack Legal Research, covering Court of Appeals for the Seventh Circuit primary law. Counsel Stack provides free access to over 12 million legal documents including statutes, case law, regulations, and constitutions.

Bluebook
Kaiser Aluminum & Chemical Corporation v. Federal Trade Commission, 652 F.2d 1324, 1981 U.S. App. LEXIS 11691 (7th Cir. 1981).

Opinion

*1327 BAKER, District Judge.

The petitioner, Kaiser Aluminum & Chemical Corporation (Kaiser), seeks review of a cease and desist order issued in 1979 by the respondent, Federal Trade Commission (Commission). The order directs Kaiser to divest itself of all the assets, title, properties, interest, rights, and privileges which Kaiser obtained from a 1974 acquisition of the Lavino Division (Lavino) of International Minerals & Chemicals Corporation (IMC). We are asked to set aside that order.

The Commission based its order on conclusions that the acquisition of Lavino by Kaiser might substantially lessen competition in a national market and submarkets for basic refractories and, as a further result, would be an unfair method of competition. The Commission’s ruling, therefore, finds a violation of § 7 of the Clayton Act, 15 U.S.C. § 18 (1976), 1 and a violation of § 5 of the Federal Trade Commission Act, 15 U.S.C. § 45 (1976). 2 The full report of the proceedings before the Commission appears at 93 F.T.C. 764 (1979).

Jurisdiction to review the Commission’s order is given by 15 U.S.C. §§ 21(c) and 45(c). 3 Since the acquisition of Lavino was consummated at the headquarters of IMC in Illinois and since one of the refractory plants acquired was located in Gary, Indiana, jurisdiction is properly vested in this court.

Both Kaiser and the Commission agree that there are two issues presented for review. Those issues are:

I. Did the Commission properly define the relevant markets within which to measure the effect upon competition of Kaiser’s acquisition of Lavino?

II. Did the Commission apply proper legal standards in concluding that, within the markets defined by the Commission, Kaiser’s acquisition of Lavino might substantially lessen competition in violation of § 7 of the Clayton Act?

We conclude that the Commission did not define the relevant markets properly and that correct legal principles were not applied in reaching the determination that the effect of the acquisition might be substantially to lessen competition.

Facts

Prior to the 1974 acquisition, Kaiser and Lavino were separately engaged in the production of refractories. Refractories are materials that are specifically resistant to the action of heat and are used in the linings of industrial furnaces and kilns. Refractories are sold in shapes or forms such as bricks or may be sold as unformed material known as specialties. Refractories are further differentiated by the chemistry of their ingredients. They are basic (alkaline) or non-basic (acidic) and are intended to correspond with the chemical character of the process with which they will be in contact in order to prevent chemical union or interaction. Refractory linings are consumed over a period of time through wear.

*1328 The primary consumer of refractories in the United States is the steel industry. Other consumers include the copper, glass, and cement industries.

Prior to its acquisition, Lavino owned production plants in Plymouth Meeting, Pennsylvania; Gary, Indiana; and Newark, California. Lavino also owned raw material producing facilities — a magnesia processing plant in Freeport, Texas and a chrome ore mine in South Africa. In the East and Midwest Lavino sold to major steel producers. In the West Lavino sold refractories to smaller copper, steel, and glass producers.

Lavino commenced business in 1887 under the name of E. J. Lavino & Co. as an importer of mineral ores for sale to the steel industry. During World War I Lavino began to manufacture refractories at its Plymouth Meeting plant. Lavino expanded its refractory manufacturing to plants in California, Indiana, and Texas during the decade 1950-1960. In 1966 the Lavino family sold the business to IMC for 26 million dollars, and the company became the Lavi-no Division of IMC, whose assets Kaiser acquired in 1974.

Lavino was regarded as a leader in the refractories business and had a reputation as an outstanding supplier of high quality products. Its product line, however, was limited, and Lavino concentrated on the production of refractories for use in the open-hearth method of steel production.

Until the 1960’s most steel production was carried on in open-hearth furnaces. During the 1950’s the basic oxygen furnace (BOF) was introduced in the steel industry as a more efficient means of steel production. The BOF consumed smaller amounts of refractories than the open-hearth furnace consumed in the production of a ton of steel, and, significantly, the BOF required its own refractories. Steelmakers could not substitute open-hearth refractories, such as those Lavino concentrated on producing, for BOF refractories.

Beginning in 1960 the open-hearth method of steel production began to decline, and the BOF began to replace the open-hearth. In 1960 BOF’s produced 3 million tons of steel while open-hearth furnaces produced 86 million tons. In 1970 BOF’s produced 77 million tons while open-hearth production fell to 20 million tons.

Lavino made only a half-hearted attempt to enter the BOF refractories market during the early 1960’s. But after the company’s acquisition by IMC, management pressed for expanded product lines to serve BOF’s and electric arc furnaces. IMC increased Lavino’s research and development budget, installed new production equipment, and began new marketing projects. These efforts did not meet with great success, however, and in 1970 a slump in the domestic steel industry triggered an IMC decision to leave the refractories business and dispose of Lavino. The Lavino Division embarked on a course of attrition. It deferred physical improvements, made deep cuts in expenditures, allowed its product quality to slip, closed its California plant (thereby abandoning its western market), closed its Texas magnesia plant and bought a long-term supply contract instead, and began to solicit buyers for the business. One firm, Didier-Werke of West Germany, seriously considered the purchase of Lavino but decided against it. In the fall of 1972 Kaiser began to consider the acquisition of portions of Lavino.

Kaiser is a manufacturer of aluminum and is a multinational conglomerate. Kaiser began producing refractories during World War II at three plants in California. Most of Kaiser’s production went to Western open-hearth steel producers, but Kaiser also sold to cement and glass producers throughout the United States. In the 1950’s Kaiser acquired refractories plants in Missouri, Ohio, Pennsylvania, and Maryland that served the glass, cement, copper, petroleum, and chemical industries. In 1956 Kaiser constructed a refractories plant in Ohio that served steelmakers.

Free access — add to your briefcase to read the full text and ask questions with AI

Related

In Re AMR Corp.
Second Circuit, 2023
Steves & Sons, Inc. v. Jeld-Wen, Inc.
290 F. Supp. 3d 507 (E.D. Virginia, 2018)
United States of America v. Anthem, Inc.
236 F. Supp. 3d 171 (District of Columbia, 2017)
United States of America v. Aetna Inc.
240 F. Supp. 3d 1 (District of Columbia, 2017)
Thompson's Gas & Electric Service, Inc. v. BP America Inc.
691 F. Supp. 2d 860 (N.D. Illinois, 2010)
Chicago Bridge & Iron Co., NV v. FTC
515 F.3d 447 (Fifth Circuit, 2008)
Federal Trade Commission v. Arch Coal, Inc.
329 F. Supp. 2d 109 (District of Columbia, 2004)
Republic Tobacco, LP v. North Atlantic Trading Co., Inc.
254 F. Supp. 2d 985 (N.D. Illinois, 2002)
Federal Trade Commission v. H.J. Heinz Co.
246 F.3d 708 (D.C. Circuit, 2001)
California v. Sutter Health System
130 F. Supp. 2d 1109 (N.D. California, 2001)
L&W/Lindco Products, Inc. v. Pure Asphalt Co.
979 F. Supp. 632 (N.D. Illinois, 1997)
United States v. Engelhard Corp.
970 F. Supp. 1463 (M.D. Georgia, 1997)
United States v. Mercy Health Services
902 F. Supp. 968 (N.D. Iowa, 1995)

Cite This Page — Counsel Stack

Bluebook (online)
652 F.2d 1324, 1981 U.S. App. LEXIS 11691, Counsel Stack Legal Research, https://law.counselstack.com/opinion/kaiser-aluminum-chemical-corporation-v-federal-trade-commission-ca7-1981.