§ 41-18-170 — Miniature train amusement ride requirements.

A miniature train amusement ride must satisfy the following requirements before the Department of Labor, Licensing and Regulation may issue a permit or renewal permit: (1) the ride must have a properly operating speedometer; (2) the ride must have a device that allows the speed of the train to be regulated and the speed of the train must be set so as to only operate at or below the maximum speed recommended by the manufacturer; (3) all drivers operating the ride must be trained to operate the ride in accordance with the manufacturer's operation recommendations; a training record for each driver must be maintained by the owner or operator of the ride as long as the driver is employed by or operates the train on behalf of the owner or operator; and each driver must be tested by the department before the driver is authorized to operate the train; a driver employed to operate the train, or who will operate the train on behalf of the owner or operator, subsequent to the department issuing the permit or renewal permit does not affect the validity of the permit, so long as the driver does not operate the train until the driver has been tested by the department; and (4) the ride must be inspected mechanically, including, but not limited to, a speed test of the train to ensure that the train is operating in accordance with the requirements of item (2), and in accordance with this chapter or regulations promulgated pursuant to this chapter, but in no case less than an annual inspection.

Legislative History

HISTORY: 2012 Act No. 129, SECTION 2, eff March 13, 2012. Editor's Note 2012 Act No. 129, SECTION 1, provides as follows: "This act may be cited as 'Benji's Law'." ARTICLE 3 Rider Safety