Pennsylvania § 4979.3 Permit for movement of float glass or flat glass for use in construction and other

Pennsylvania Statutes

§ 4979.3 — Permit for movement of float glass or flat glass for use in construction and other

Pennsylvania § 4979.3

JurisdictionPennsylvania

Title 75VEHICLES

PartPART IV

Ch. 49SIZE, WEIGHT AND LOAD

Subch.SPECIAL PERMITS FOR EXCESSIVE

This text of Pennsylvania § 4979.3 (Permit for movement of float glass or flat glass for use in construction and other) is published on Counsel Stack Legal Research, covering Pennsylvania primary law. Counsel Stack provides free access to over 12 million legal documents including statutes, case law, regulations, and constitutions.

Bluebook

75 Pa. Cons. Stat. § 4979.3 (2026).

Text

(a)General rule.--An annual permit may be issued authorizing the movement on specified highways of float glass or flat glass for use in construction and other end uses which exceeds the maximum vehicle gross weight specified in Subchapter C (relating to maximum weights of vehicles).

(b)Specifications.--

(1)The weight of any vehicle permitted under this section may not exceed 100,000 pounds overall gross weight, shall be a five axle combination - three axle truck tractor and shall have the following maximum axle weight limits for all axles:

(2)The spacing between axle 1 and axle 2 must be a minimum of 15 feet.

(3)The center-to-center distance between the last drive axle of the truck tractor and the first axle of the semitrailer must be a minimum of 31 feet 6 inches.

(4)The spacin

Free access — add to your briefcase to read the full text and ask questions with AI

(a) General rule.--An annual permit may be issued authorizing the movement on specified highways of float glass or flat glass for use in construction and other end uses which exceeds the maximum vehicle gross weight specified in Subchapter C (relating to maximum weights of vehicles).

(b) Specifications.--

(1) The weight of any vehicle permitted under this section may not exceed 100,000 pounds overall gross weight, shall be a five axle combination - three axle truck tractor and shall have the following maximum axle weight limits for all axles:

(2) The spacing between axle 1 and axle 2 must be a minimum of 15 feet.

(3) The center-to-center distance between the last drive axle of the truck tractor and the first axle of the semitrailer must be a minimum of 31 feet 6 inches.

(4) The spacing between tandem axles must be a minimum of 4 feet 4 inches for the truck tractor and 5 feet 2 inches for the semitrailer.

(c) Operation limitations.--

(1) Except as provided in paragraph (2), a vehicle operating under a permit authorized under this section may be driven 24 hours a day, seven days a week.

(2) Movement under this paragraph is not authorized during any of the following:

(i) A holiday period specified in department regulations or in the permit.

(ii) Inclement weather, as defined in department regulations.

(d) Interstate highways.--No permit may be issued for this type of movement upon an interstate highway.

Legislative History

(June 25, 1999, P.L.164, No.23, eff. 60 days; June 22, 2001, P.L.559, No.37, eff. 60 days) 2001 Amendment.Act 37 amended subsec. (b). 1999 Amendment.Act 23 added section 4979.3. Cross References.Section 4979.3 is referred to in sections 1943, 4962 of this title.