Pineda v. Ford Motor Co.

520 F.3d 237, 75 Fed. R. Serv. 1269, 2008 U.S. App. LEXIS 6091, 2008 WL 756698
CourtCourt of Appeals for the Third Circuit
DecidedMarch 24, 2008
Docket07-1191
StatusPublished
Cited by381 cases

This text of 520 F.3d 237 (Pineda v. Ford Motor Co.) is published on Counsel Stack Legal Research, covering Court of Appeals for the Third Circuit primary law. Counsel Stack provides free access to over 12 million legal documents including statutes, case law, regulations, and constitutions.

Bluebook
Pineda v. Ford Motor Co., 520 F.3d 237, 75 Fed. R. Serv. 1269, 2008 U.S. App. LEXIS 6091, 2008 WL 756698 (3d Cir. 2008).

Opinion

OPINION

IRENAS, Senior District Judge.

Appellant Jose Pineda is an automobile technician who was injured when the rear *240 liftgate glass of a 2002 Ford Explorer shattered. He filed a products liability action against Appellee Ford Motor Company in the United States District Court for the Eastern District of Pennsylvania and retained an expert to support his claims. After extensive discovery and a Daubert hearing, 1 the District Court 2 ruled that Pineda’s proffered expert witness was not qualified to testify and that his methodology was not reliable. The District Court then granted Ford’s motion to exclude the testimony of Pineda’s expert and its motion for summary judgment. For the reasons set forth below, we will reverse both decisions and remand for further proceedings.

I.

Pineda was employed as an automobile technician by Murphy Lincoln-Mercury in West Chester, Pennsylvania. On July 18, 2002, he worked to replace several components of the rear liftgate on a 2002 Ford Explorer. Pineda initially examined the Explorer on July 2, when the owner brought the vehicle to the dealership for repair because the rear liftgate would not close properly. Pineda determined that one of the hinges that connected the lift-gate glass to the body of the Explorer was damaged. He also knew that, in April of 2001, Ford issued a Special Service Instruction for repair of the liftgate brackets on 2002 Explorers built between February 5 and March 30, 2001. 3 The brackets connected the lift cylinders, which supported the rear liftgate in the open position, to each side of the liftgate glass. Pineda told the owner of the vehicle to refrain from using the rear liftgate until it could be repaired. He then ordered replacement lift cylinders, liftgate brackets, and liftgate hinges, all of which were available for installation on July 18.

That morning, Pineda replaced the lift cylinders and liftgate brackets without incident. Later in the afternoon, he began to replace the liftgate hinges. During his deposition, Pineda described what happened next:

It was right after lunch, somewhere around 1:00, when I finished to install the hinge on the left side and moved to the right side. I got the book because [there] was no information related to the torque specs on the hinge, so I got the book, torqued the hinge [on the glass side] to the specs of the book, then put the nut on the body side. When I finished torquing the nut on the body side, I hear a click and felt like the glass was exploding. I closed my eyes and I felt something hit my leg.

I stepped back with my eyes closed, two steps. I was in so much pain on my leg *241 that I have to open my eyes, and I saw my calf wide open.

Pineda filed a complaint against Ford on July 16, 2004, in the Eastern District of Pennsylvania. The complaint alleged that the liftgate glass and hinges on the 2002 Ford Explorer were defective in design and that Ford failed to adequately warn of the dangerous condition. 4

In order to satisfy his burden of proof on the products liability claims, Pineda retained Craig D. Clauser, P.E., as an expert. Clauser produced a report on September 30, 2005. It concluded that the liftgate glass shattered because its “design was defective in that it was only marginally able to resist fracture in its intended service and the pertinent manual and bulletins lacked adequate instructions and warnings.” Clauser’s report noted that “[n]o improper action by Mr. Pineda caused this incident to occur.” 5

Ford deposed Clauser on March 31, 2006. He stated at the deposition that his design defect opinion was based on his comparison of warranty claims for 2002 and 2003 model year Ford Explorers. Specifically, his analysis of performance reviews based on the warranty claims led him to conclude that 2002 models had a design defect related to the liftgate glass and hinges. His opinion was also based on third-party opinions he found on the internet at BlueOvalNews.com. 6

As to his failure to warn opinion, Clau-ser testified that the 2002 Explorer’s service manual did not provide specific, step-by-step instructions for replacing the lift-gate brackets and hinges and reconnecting them to the liftgate glass. He further testified that the service manual failed to *242 warn that the need for following such instructions was a safety issue. Clauser admitted that, in reaching his conclusions, he did not perform any objective testing of his own, e.g., stress analysis or other experiments on the liftgate glass of the vehicle at issue or on 2002 Explorers generally.

After the deposition, Ford filed motions to exclude Clauser’s testimony and for summary judgment. Alternatively, it moved for a pretrial Daubert hearing. The bases for these motions were that Clauser was unqualified to provide expert testimony and that, even if he were qualified, Clauser’s testimony was unreliable under Federal Rule of Evidence 702 and Daubert. 7 The District Court granted the motion for a Daubert hearing, which was held on September 28, 2006. Prior to the hearing, on July 11, 2006, Clauser provided a supplemental report, in which his opinions from the first report remained unchanged. Nonetheless, at the start of the hearing, Pineda voluntarily withdrew his design defect claim and proceeded only on his failure to warn claim.

Clauser was the only witness to testify at the Daubert hearing. Pineda’s counsel first asked Clauser to discuss his credentials as a professional engineer with experience in materials analysis and systems failure analysis. Clauser admitted that he was not a warnings expert, except to the extent that “a warning and instructions” are “solution[s] to an engineering problem.” He also testified about Ford’s 2004 Safety Recall Instruction (the “SRI”), which described the procedure for replacing the liftgate brackets and hinges on the 2002 Ford Explorer. Clauser stated that the SRI, unlike the 2002 service manual used by Pineda, provided adequate warnings and proper, detailed instructions for the replacement of the liftgate brackets and hinges. 8

By Opinion and Order dated November 15, 2006, the District Court granted Ford’s motion to exclude Clauser’s testimony in its entirety because: (1) Clauser admitted that he was not qualified as a warnings expert; (2) when discussing alternative warnings, Clauser could not compare the 2002 service manual to the SRI pursuant to Federal Rule of Evidence 407; and (3) Clauser’s testimony was not based on an accepted methodology, i.e., his testimony was unreliable.

Free access — add to your briefcase to read the full text and ask questions with AI

Related

Cite This Page — Counsel Stack

Bluebook (online)
520 F.3d 237, 75 Fed. R. Serv. 1269, 2008 U.S. App. LEXIS 6091, 2008 WL 756698, Counsel Stack Legal Research, https://law.counselstack.com/opinion/pineda-v-ford-motor-co-ca3-2008.