Krantz v. Gehl Co.

431 N.W.2d 675, 146 Wis. 2d 398, 1988 Wisc. App. LEXIS 776
CourtCourt of Appeals of Wisconsin
DecidedSeptember 1, 1988
Docket87-1905
StatusPublished
Cited by2 cases

This text of 431 N.W.2d 675 (Krantz v. Gehl Co.) is published on Counsel Stack Legal Research, covering Court of Appeals of Wisconsin primary law. Counsel Stack provides free access to over 12 million legal documents including statutes, case law, regulations, and constitutions.

Bluebook
Krantz v. Gehl Co., 431 N.W.2d 675, 146 Wis. 2d 398, 1988 Wisc. App. LEXIS 776 (Wis. Ct. App. 1988).

Opinions

DYKMAN, J.

Gerard Krantz appeals from a judgment dismissing his complaint. Krantz was injured while cleaning Gehl-manufactured farm machinery and sued Gehl for damages. The trial court granted Gehl’s motion for a directed verdict. The issue is whether Krantz’s negligence exceeded that of Gehl as a matter of law. We conclude that it did, and affirm.

FACTS

In 1984, Krantz was injured while unloading haylage1 from a Gehl forage box.2 The forage box, while self-unloading, has no power of its own. The self-unloading features are powered by connecting the forage box to a power take-off on a tractor. Conveyors (feeder aprons) move the haylage to the front end of [401]*401the forage box where it passes through a set of three "beaters,” positioned one above the other. The beaters are large steel cylinders from which steel blades protrude.

The beaters are controlled by beater clutch levers which are located at the front side corners of the forage box. Pulling the beater clutch lever out and down activates the beaters while pushing the lever up and in disengages the beater drive. The beaters shred the haylage and deposit it onto a cross-conveyor. The cross-conveyor carries the haylage through the cross-conveyor discharge opening to a blower unit located next to the forage box, which blows the haylage into the silo for storage.

Nothing in the forage box operates unless its "telescoping drive connection” is connected to a tractor’s power take-off shaft. Engaging the power take-off automatically engages the cross-conveyor. The feeder aprons are only engaged when the beaters are "on.” A separate control regulates the speed of the feeder aprons, which may be operated at one of three speeds: "low,” "high,” or "sweep.” "Sweep” speed is used to clean out the forage box after it has been emptied. Just above the cross-conveyor discharge opening, at roughly eye level, is a decal that says:

DANGER
KEEP HANDS OUT.
ROTATING COMPONENTS CAN CATCH HANDS.
FAILURE TO HEED CAN RESULT IN DEATH OR
SERIOUS INJURY.

[402]*402On July 18,1984 at about 5 p.m., after Krantz had unloaded the last load of the day, he set the feeder apron control at "sweep” speed to clean the box so there would be no hay remaining to rot the box. He let the beaters and conveyors run at "sweep” speed for "at least five minutes.” At the end of the process there was still some material left near the cross-conveyor by the discharge opening. The material was approximately seven inches deep and extended three to five feet back into the box from the cross-conveyor.

Intending to remove the remaining material manually, Krantz reached into the cross-conveyor discharge opening as far as he could with his right arm to sweep the material out. While he reached under the beater blades, his left arm accidentally turned on the beater control lever and the beater blades injured his right arm. Krantz used his left hand to shut the beaters off with the beater control lever. While struggling to free his right arm he kept his left hand on the beater control lever and accidentally turned it back on. Hearing the commotion from the barn, Krantz’s brother came and shut the forage box off.

Krantz sued Gehl for damages, alleging that Gehl had negligently designed the forage box, and that such negligence directly caused Krantz’s injuries. At the conclusion of Krantz’s case, Gehl moved for a directed verdict, asserting that Krantz was negligent as a matter of law and that his negligence exceeded that of Gehl as a matter of law. Basing its decision on the reasoning in Schuh v. Fox River Tractor Co., 63 Wis. 2d 728, 743-45, 218 N.W.2d 279, 287-88 (1974),3 the [403]*403trial court granted Gehl’s motion for a directed verdict, concluding that Krantz was negligent and that his negligence exceeded Gehl’s. The court entered judgment against Krantz.

STANDARD OF REVIEW

In determining whether a directed verdict should be granted, the evidence is viewed most favorably to the party against whom the verdict is sought to be directed. The test is whether there is any credible evidence which under a reasonable view would support a verdict contrary to that which is sought. A trial judge should, except in the clearest of cases, withhold ruling on a directed verdict and ordinarily permit the question to go to the jury.

[404]*404Village of Menomonee Falls v. Michelson, 104 Wis. 2d 137, 154, 311 N.W.2d 658, 666 (Ct. App. 1981) (citations omitted.) The test on appeal is whether the trial court was clearly wrong. State v. Leach, 124 Wis. 2d 648, 665, 370 N.W.2d 240, 249 (1985). This test requires us to give deference to a trial court’s decision. "Where the causal negligence of the plaintiff is greater than that of the defendant the trial court has a duty to so hold as a matter of law.” Stewart v. Wulf, 85 Wis. 2d 461, 471, 271 N.W.2d 79, 84 (1978).

Krantz testified to the following: that he had operated forage boxes on a continuous basis as needed for six or seven years before the accident and knew all about the safety devices, safety decals and warnings on the Gehl forage box; that before his accident, he knew he needed to follow a mandatory safety shutdown procedure every time before manually cleaning the forage box; that he knew that the parts of the procedure included shutting off the power take-off, shutting off the tractor engine, and then disconnecting the power take-off from its mating part; that had he followed this procedure, or any one part of it, his accident would not have happened; that he followed no part of this procedure; that he knew that the beaters in the forage box were potentially dangerous even if they were not moving because unless the power take-off was disengaged there was a "minute possibility that the beaters might start up when you don’t want them to”; that he knew he was supposed to keep his hands out of the discharge opening.

Krantz concedes he could have prevented the accident if he had followed the mandatory shutdown procedure. However, he argues that his behavior and actions were "undoubtedly foreseeable by the manufacturer and arguably reasonable under the circum[405]*405stances” because the machine wasn’t unloading itself, he was enticed by the placement and location of the beater clutch lever near the discharge opening, he was under time pressure and the environmental conditions were less than ideal.

Even if we assume that Gehl was negligent as a matter of law because of the design and location of the beater clutch control lever,4 we agree with the trial court that Krantz’s negligence exceeded Gehl’s as a matter of law. Krantz admitted that if he had followed the mandatory shutdown procedure his accident would not have happened.5

Free access — add to your briefcase to read the full text and ask questions with AI

Related

Hansen v. New Holland North America, Inc.
574 N.W.2d 250 (Court of Appeals of Wisconsin, 1997)
Krantz v. Gehl Co.
431 N.W.2d 675 (Court of Appeals of Wisconsin, 1988)

Cite This Page — Counsel Stack

Bluebook (online)
431 N.W.2d 675, 146 Wis. 2d 398, 1988 Wisc. App. LEXIS 776, Counsel Stack Legal Research, https://law.counselstack.com/opinion/krantz-v-gehl-co-wisctapp-1988.