Davies v. Carter Carburetor, Division ACF Industries, Inc.

429 S.W.2d 738, 1968 Mo. LEXIS 897
CourtSupreme Court of Missouri
DecidedJuly 8, 1968
Docket52621
StatusPublished
Cited by51 cases

This text of 429 S.W.2d 738 (Davies v. Carter Carburetor, Division ACF Industries, Inc.) is published on Counsel Stack Legal Research, covering Supreme Court of Missouri primary law. Counsel Stack provides free access to over 12 million legal documents including statutes, case law, regulations, and constitutions.

Bluebook
Davies v. Carter Carburetor, Division ACF Industries, Inc., 429 S.W.2d 738, 1968 Mo. LEXIS 897 (Mo. 1968).

Opinion

MARSHALL CRAIG, Special Judge.

This appeal is from judgment in the Circuit Court affirming an award of the Industrial Commission of this State in favor of the employee (claimant), Carl Davies. Appellant (employer) was ordered to pay claimant $7,350 for medical and hospital care and treatment; the sum of $42.50 per week for a total of 300 weeks and then $27.50 per week for the balance of his life, for permanent disability. The employer denies responsibility to claimant for injuries, if any, which he claims to have sustained. The facts pertinent to the issues are here set out and will be considered in the light most favorable to the prevailing party. Harper v. Home Imp. Co., et al., Mo.Sup., 235 S.W.2d 558. We must affirm the award if it is supported by competent and substantial evidence on the whole record. We cannot substitute our judgment on the evidence for that of the Commission.

On October 8, 1962, claimant was in the employ of the appellant. He had been so employed for about three years. At the time of the trial claimant was thirty-eight years of age. On the day in question, he reported for work at 3:30 P.M. His duties consisted of running an onsrud mill which was a revolving turntable on which parts of carburetors were placed to be moved through cutters of a circular machine. The parts were placed on the turntable at a point on the north arc of the machine, and passed counterclockwise to plaintiff’s left. After they passed through the cutters, they were picked up by the claimant and placed on “flats.” These were metal instruments about four inches above the ground and rested on metal runners. They were then transferred to “pans” which were metal instrumentalities about six inches to ten inches deep. They weighed about eleven pounds empty and from thirty-five to forty pounds when full of carburetor components, and were about three feet long. The sides of the pans were not vertical, but slanted out from the bottom to the tops. The sides near the tops were curled from the top down so as to make a lengthwise extrusion of metal to be used as a handle. They were of aluminum alloy. The material he was working with and handling were carburetor bodies, and twelve such bodies were loaded on each pan.

After the carburetor bodies had moved counterclockwise to the south side of the table, plaintiff picked up each carburetor body and placed it in a pan on the left side of the turntable. This type of maneuver was a regular routine and he did this in the same manner every day. He picked up the carburetor body on top of the pile then took the second one and worked down toward the bottom of the pan. As he worked toward the bottom of the pan, the employee customarily turned slightly to the right or left to get hold of these pans. His testimony on cross-examination as to these maneuvers was as follows:

“Q And when you did that, was it your custom to turn slightly to the right or the left to get hold of these pans?
“A Yes.
“Q You had to do that, didn’t you?
“A Yes.
*742 “Q No other way to do it, was there?
“A Not to my knowledge.
“Q That’s the way you did it?
“A Yes.
“Q And then, as you reached lower down, did you, when you got to the second tier there, let’s say number four from the bottom, you reached to the closest pan and worked your way over to the opposite end of the flat, didn’t you?
“A Yes.
“Q Did you do that with each one of them?
“A I’m pretty sure.
“Q Each tier, I mean.
“A I’m pretty sure.
“Q You turned, reached over and got the end one? The one closest to you. You didn’t reach over and get the one on the opposite end first, did you? You always picked up the one closest to you?
“A Yes.
“Q Began at the top, turned around to your right somewhat, turned hack and laid it on your table?
“A Yes.
“Q All the time you did that; right along?
“A Yes.
“Q You worked it the same way on the day this occurred?
“A Right.
“Q Right?
“A Right.
“Q And you made the same character of movement and about the same steps every time. You had to didn’t you ?
“A Every time.
“Q You had "to stop (stoop) lower as you got down into the lower tiers?
“A That’s correct.
“Q That was true of every one of them, wasn’t it — every flat?
“A Yes.”

At the time of the occurrence from which he claims his injury, he was lifting the pan straight up. It was the last layer, the one closest to the floor. He thought he had lifted it, at that time, approximately a foot above the pan at which time he felt a pain and he set it back down and let go of it.

As to the exact occurrence at the time, the evidence was as follows:

“Q (Mr. Connaghan) You may describe what kind of position you were in.
“A I was turned to the right. My body was twisted. I bent over the flat, picked up the pan of parts and, as I came up, I went off balance with this pan of parts and I ■felt this pain in my back — this sharp pain; and I was standing with my left foot forward and my right foot back and, when this threw me off balance, my foot — my right foot come back and, as I say, this pain shot through my back. I straightened up and that pain diminished, but an ache formed, you know, a pain, and it gradually just got worse.
“THE REFEREE: Just a moment — had you finished your testimony?
“THE WITNESS: So far, yes.
“THE REFEREE: Your left foot was forward and your right foot was back and you were turned to the right and you bent to pick up this pan?
“THE WITNESS: Yes sir.
“THE REFEREE: You said that you went off balance and you also used the term ‘when it threw me off balance’, unquote, could you tell me a little more what you mean by that?
*743 “THE WITNESS: The fact that I was twisted in lifting this pan of parts, — the position I was in was what threw me off balance.
“THE REFEREE: You may proceed, Mr. Connaghan.
“Q (Mr.

Free access — add to your briefcase to read the full text and ask questions with AI

Related

Brown v. SAIF
Oregon Supreme Court, 2017
Brown v. SAIF Corp.
391 P.3d 773 (Oregon Supreme Court, 2017)
Milton Young v. Boone Electric Cooperative
462 S.W.3d 783 (Missouri Court of Appeals, 2015)
Lewey v. Farmer
362 S.W.3d 429 (Missouri Court of Appeals, 2012)
Spencer v. Sac Osage Electric Co-op, Inc.
302 S.W.3d 792 (Missouri Court of Appeals, 2010)
Ellis v. Missouri State Treasurer
302 S.W.3d 217 (Missouri Court of Appeals, 2009)
in Matter of Care v. State
199 S.W.3d 223 (Missouri Court of Appeals, 2006)
ADP Dealer Services Group v. Carroll Motor Co.
195 S.W.3d 1 (Missouri Court of Appeals, 2005)
Goddard v. State
144 S.W.3d 848 (Missouri Court of Appeals, 2004)
Shelton v. City of Springfield
130 S.W.3d 30 (Missouri Court of Appeals, 2004)
Kerns v. Midwest Conveyor
126 S.W.3d 445 (Missouri Court of Appeals, 2004)
Wilmeth v. TMI, INC.
26 S.W.3d 476 (Missouri Court of Appeals, 2000)
Lusher v. Gerald Harris Construction, Inc.
993 S.W.2d 537 (Missouri Court of Appeals, 1999)
Campbell v. Citicorp Mortgage, Inc.
924 S.W.2d 323 (Missouri Court of Appeals, 1996)
Sifferman v. Sears, Roebuck and Co.
906 S.W.2d 823 (Missouri Court of Appeals, 1995)
Lawton v. Trans World Airlines, Inc.
885 S.W.2d 768 (Missouri Court of Appeals, 1994)
Stallings v. Washington University
794 S.W.2d 264 (Missouri Court of Appeals, 1990)
Crum v. Sachs Electric
769 S.W.2d 131 (Missouri Court of Appeals, 1989)

Cite This Page — Counsel Stack

Bluebook (online)
429 S.W.2d 738, 1968 Mo. LEXIS 897, Counsel Stack Legal Research, https://law.counselstack.com/opinion/davies-v-carter-carburetor-division-acf-industries-inc-mo-1968.