§ 33-29-801 — Maps, plats, plans and designs for filing or recording to be certified by professional engineer or professional land surveyor; exception; size of maps

(a) Except for filings with the oil and gas commission
pursuant to rules of the oil and gas commission, all maps,
plats, plans, designs and all other engineering and surveying
documents required to be filed or recorded in the state
engineer's office, the office of state lands and investments,
all county clerks' offices, all city or town offices, or any
other office of public record in the state of Wyoming, shall
comply with the following requirements:
(i) Be made by or under the responsible charge of a
professional engineer or professional land surveyor and be
signed by and bear the seal of the professional engineer or
professional land surveyor;
(ii) Hardcopy originals shall be drawn in either
waterproof black ink or acetate ink or shall be an acceptable
photographic or other kind of reproduction on good quality
polyester base drafting film in a minimum thickness of four-
thousandths (.004) inch or as otherwise required by the
receiving entity;
(iii) Maps formatted as required by the receiving
entity may be submitted in electronic form as provided by the
Uniform Electronic Transactions Act, W.S. 40-21-101 through
40-21-119;
(iv) Hardcopy documents shall conform to the sizes
provided by board rule.
(b) Repealed by Laws 2017, ch. 43, § 2.
(c) Repealed by Laws 2017, ch. 43, § 2.
(d) Repealed by Laws 2017, ch. 43, § 2.
(e) The state engineer may adopt rules and regulations
which provide exceptions to paragraph (a)(i) of this section for
projects which, because of their size, nature or location, an
exception would not impede upon public safety or the integrity
of a water right.