Utah § 53-8-206 Safety inspection -- Station requirements -- Permits not transferable -- Certificate of inspection -- Fees -- Unused certificates -- Suspension or revocation of permits.

Utah Statutes

§ 53-8-206 — Safety inspection -- Station requirements -- Permits not transferable -- Certificate of inspection -- Fees -- Unused certificates -- Suspension or revocation of permits.

Utah § 53-8-206

Title 53Public Safety Code

Ch. 53-8Utah Highway Patrol Act

Part 53-8-2Motor Vehicle Safety Inspection Act

This text of Utah § 53-8-206 (Safety inspection -- Station requirements -- Permits not transferable -- Certificate of inspection -- Fees -- Unused certificates -- Suspension or revocation of permits.) is published on Counsel Stack Legal Research, covering Utah primary law. Counsel Stack provides free access to over 12 million legal documents including statutes, case law, regulations, and constitutions.

Bluebook

Utah Code Ann. § 53-8-206 (2026).

Text

(1)The safety inspection required under this part may only be performed:

(1)(a) by a person certified by the division as a safety inspector; and

(1)(b) at a safety inspection station with a valid safety inspection station permit issued by the division.

(2)(2)(a) A safety inspection station permit may not be assigned, or transferred, or used at any location other than a designated location.

(2)(b) The holder of a safety inspection station permit shall post the permit in a conspicuous place at the location designated in the permit.

(3)If required by the division, the safety inspector shall keep a record and file a report of every safety inspection and every safety inspection certificate issued.

(4)A safety inspection station holding a safety inspection station permit issued by the divis

Free access — add to your briefcase to read the full text and ask questions with AI

(1) The safety inspection required under this part may only be performed:

(1)(a) by a person certified by the division as a safety inspector; and
(1)(b) at a safety inspection station with a valid safety inspection station permit issued by the division.
(2) (2)(a) A safety inspection station permit may not be assigned, or transferred, or used at any location other than a designated location.
(2)(b) The holder of a safety inspection station permit shall post the permit in a conspicuous place at the location designated in the permit.
(3) If required by the division, the safety inspector shall keep a record and file a report of every safety inspection and every safety inspection certificate issued.
(4) A safety inspection station holding a safety inspection station permit issued by the division may charge a reasonable fee for labor in performing safety inspections, not to exceed:

(4)(a) $14 or less for motorcycles and street-legal all-terrain vehicles;
(4)(b) unless Subsection (4)(a) or (c) applies, $30 or less for motor vehicles; or
(4)(c) $40 or less for 4-wheel drive, split axle, and any motor vehicles that necessitate disassembly of front hub or removal of rear axle for inspection.
(5) (5)(a) A safety inspection station may return to the division unused safety inspection certificates in a quantity of 10 or more.
(5)(b) The division shall reimburse the station for the cost of the returned safety inspection certificates.
(6) (6)(a) Upon receiving notice of the suspension or revocation of a safety inspection station permit and after the conclusion of any adjudicative proceedings upholding the suspension or revocation, the safety inspection station permit holder shall:
(6)(a)(i) immediately terminate all safety inspection activities; and
(6)(a)(ii) return all safety inspection certificates and the safety inspection station permit to the division.
(6)(b) The division shall issue a receipt for all unused safety inspection certificates.