§ 39-27-5. Efficiency standards.
(a) Not later than June 1, 2006, the commission, in consultation with the state building
commissioner and the chief of energy and community services, shall adopt regulations,
in accordance with the provisions of chapter 35 of title 42, establishing minimum efficiency standards for the types of new products set forth
in §â€‚39-27-4(a). The regulations shall provide for the following minimum efficiency standards:
(1) Automatic commercial icemakers shall meet the energy efficiency requirements shown
in table A-7 of §â€‚1605.3 of the California Code of Regulations, Title 20: Division
2, Chapter 4, Article 4: Appliance Efficiency Regulations as adopted on December 15,
2004.
(2) Commercial clothes washers shall meet the requirements shown in Table P-4 of §â€‚1605.3
of the California Code of Regulations, Title 20: Division 2, Chapter 4, Article 4:
Appliance Efficiency Regulations in effect on December 15, 2004.
(3) Commercial pre-rinse spray valves shall have a flow rate equal to or less than one
and six-tenths gallons (1.6 gals.) per minute.
(4) Commercial refrigerators, freezers, and refrigerator-freezers shall meet the minimum
efficiency requirements shown in Table A-6 of §â€‚1605.3 of the California Code of Regulations,
Title 20: Division 2, Chapter 4, Article 4: Appliance Efficiency Regulations as adopted
on December 15, 2004, except that pulldown refrigerators with transparent doors shall
meet a requirement five percent (5%) less stringent than shown in the California regulations.
(5) High-intensity discharge lamp ballasts shall not be designed and marketed to operate
a mercury vapor lamp.
(6) Illuminated exit signs shall have an input power demand of five watts (5 W) or less
per illuminated face.
(7) Large packaged air-conditioning equipment shall meet a minimum energy efficiency ratio
of:
(i) Ten (10.0) for air conditioning without an integrated heating component or with electric
resistance heating integrated into the unit;
(ii) Nine and eight tenths (9.8) for air conditioning with heating other than electric
resistance integrated into the unit;
(iii) Nine and five tenths (9.5) for air conditioning with heating other than electric resistance
integrated heating component or with electric resistance heating integrated into the
unit;
(iv) Nine and three tenths (9.3) for air-conditioning heat pump equipment with heating
other than electric resistance integrated into the unit. Large packaged air-conditioning
heat pumps shall meet a minimum coefficient of performance in the heating mode of
three and two tenths (3.2) (measured at a high temperature rating of forty-seven (47)
degrees F db).
(8) Low-voltage dry-type distribution transformers shall meet the Class 1 efficiency levels
for low-voltage distribution transformers specified in Table 4-2 of the "Guide for
Determining Energy Efficiency for Distribution Transformers� published by the National
Electrical Manufacturers Association (NEMA Standard TP-1-2002).
(9) Metal-halide lamp fixtures that operate in a vertical position and are designed to
be operated with lamps rated greater than or equal to one hundred fifty watts (150
W) but less than or equal to five hundred watts (500 W) shall not contain a probe-start
metal-halide lamp ballast.
(10) Single-voltage external AC to DC power supplies shall meet the tier-one energy-efficiency
requirements shown in Table U-1 of §â€‚1605.3 of the California Code of Regulations,
Title 20: Division 2, Chapter 4, Article 4: Appliance Efficiency Regulations as adopted
on December 15, 2004. This standard applies to single-voltage AC to DC power supplies
that are sold individually and to those that are sold as a component of or in conjunction
with another product. Single-voltage external AC to DC power supplies that are made
available by a product manufacturer as service parts or spare parts for its products
manufactured prior to January 1, 2008, shall be exempt from this provision.
(11) Torchieres shall not use more than one hundred ninety watts (190 W). A torchiere shall
be deemed to use more than one hundred ninety watts (190 W) if any commercially available
lamp or combination of lamps can be inserted in its socket(s) and cause the torchiere
to draw more than one hundred ninety watts (190 W) when operated at full brightness.
(12) Traffic signal modules shall meet the product specification of the "Energy Star Program
Requirements for Traffic Signals� developed by the U.S. Environmental Protection Agency
that took effect in February 2001 and shall be installed with compatible, electronically-connected
signal-control interface devices and conflict-monitoring systems.
(13) Unit heaters shall be equipped with an intermittent ignition device and shall have
either power venting or an automatic flue damper.
(b) Not later than June 1, 2007, the commission, in consultation with the state building
commissioner and the chief of energy and community services, shall adopt regulations,
in accordance with the provisions of chapter 35 of title 42, establishing minimum efficiency standards for the types of new products set forth
in §â€‚39-27-4(b). The regulations shall provide for the following minimum efficiency standards.
(1) Bottle-type water dispensers designed for dispensing both hot and cold water shall
not have standby energy consumption greater than one and two-tenths kilowatt-hours
(1.2 KWh) per day.
(2) Commercial hot food holding cabinets shall have a maximum idle energy rate of forty
watts (40 W) per cubic foot of interior volume.
(3)(i) Residential furnaces and residential boilers shall comply with the following Annual
Fuel Utilization Efficiency (AFUE) and electricity ratio values:
| Product Type |
Minimum AFUE |
Maximum
electricity ratio
|
| Natural gas and propane-fired furnaces |
90% |
2.0% |
| Oil-fired furnaces>94,000 |
|
|
| Btu/hour in capacity |
83% |
2.0% |
| Oil-fired furnaces>94,000 |
|
|
| Btu/hour in capacity |
83% |
2.3% |
| Natural gas and oil, and propane-fired hot water residential boilers |
84% |
Not applicable |
| Natural gas, oil, and propane-fired steam residential boilers |
82% |
Not applicable |
(ii) The chief of energy and community services shall adopt rules to provide for exemptions
from compliance with the foregoing residential furnace or residential boiler AFUE
standards at any building, site, or location where complying with the standards would
be in conflict with any local zoning ordinance, fire code, building or plumbing code,
or other rule regarding installation and venting of residential furnaces or residential
boilers.
(iii) The provisions of subsection (b) shall be effective upon determination by the chief
of energy and community services that the same or substantial corresponding standards
have been enacted in two (2) New England states.
(4)(i) State-regulated incandescent reflector lamps shall meet the minimum average lamp efficacy
requirements for federally-regulated incandescent reflector lamps contained in 42 U.S.C. §â€‚6295(i)(1)(B).
(ii) The following types of incandescent reflector lamps are exempt from these requirements:
(A) Lamps, rated at fifty watts (50 W) or less of the following types: BR30, BR40, ER30,
and ER40;
(B) Lamps, rated at sixty-five watts (65 W) of the following types: BR30, BR40, and ER40;
and
(C) R20 lamps of forty-five watts (45 W) or less.
(5)(i) Walk-in refrigerators and walk-in freezers with the applicable motor types shown in
the table below shall include the required components shown.
| MOTOR Type |
Required Components |
| All |
Interior lights: light sources with an efficacy of forty-five (45) lumens per watt
or more, including ballast losses (if any). This efficacy standard does not apply
to LED light sources until January 1, 2010.
|
| All |
Automatic door closers that firmly close all reach-in doors. |
| All |
Automatic door closers that firmly close all walk-in doors no wider than 3.9 feet
and no higher than 6.9 feet that have been closed to within one inch of full closure.
|
| All |
Wall, ceiling, and door insulation at least R-28 for refrigerators and at least R-34
for freezers
|
| All |
Floor insulation at least R-28 for freezers (no requirements for refrigerators) |
| Condenser fan motors of under one horsepower |
Electronically commutated motors, Permanently split capacitor-type motors Polyphase
motors of one half (½) horsepower or more
|
| Single-phase evaporator fan motors of under one horsepower and less than four hundred
sixty (460) volts
|
Electronically commutated motors |
(ii) In addition to the requirements in subsection (b)(5)(i), walk-in refrigerators and
walk-in freezers with transparent reach-in doors shall meet the following requirements:
transparent reach-in doors shall be of triple-pane glass with either heat-reflective
treated glass or gas fill; if the appliance has an anti-sweat heater without anti-sweat
controls, then: the appliance shall have a total door rail, glass, and frame heater
power draw of no more than forty watts (40 W) if it is a freezer or seventeen watts
(17 W) if it is a refrigerator per foot of door frame width; and if the appliance
has an anti-sweat heater with anti-sweat heat controls, and the total door rail, glass,
and frame heater power draw is more than forty watts (40 W) if it is a freezer or
seventeen watts (17 W) if it is a refrigerator per foot of door frame width, then:
the anti-sweat heat controls shall reduce the energy use of the anti-sweat heater
in an amount corresponding to the relative humidity in the air outside the door or
to the condensation on the inner-glass pane.