Pennsylvania § 4982 Reducing or readjusting loads of vehicles

Pennsylvania Statutes

§ 4982 — Reducing or readjusting loads of vehicles

Pennsylvania § 4982

JurisdictionPennsylvania

Title 75VEHICLES

PartPART IV

Ch. 49SIZE, WEIGHT AND LOAD

Subch.MEASURING AND ADJUSTING VEHICLE

This text of Pennsylvania § 4982 (Reducing or readjusting loads of vehicles) is published on Counsel Stack Legal Research, covering Pennsylvania primary law. Counsel Stack provides free access to over 12 million legal documents including statutes, case law, regulations, and constitutions.

Bluebook

75 Pa. Cons. Stat. § 4982 (2026).

Text

(a)Violation of weight limitations.--If the gross weight or the weight upon any wheel, tire, axle or group of axles of a vehicle or combination exceeds the maximum allowed, the driver shall reduce or readjust the load so that the gross weight and the weight upon each wheel, tire, axle or group of axles will not exceed the maximum weights permitted under this chapter.

(b)Violation of size limitations.--If the load upon any vehicle or combination is such that the size limitations of this chapter are exceeded, the driver shall reduce or reposition the load so that it does not exceed the size limitations.

(c)Load adjustment to avoid prosecution.--If the gross weight of the vehicle or combination does not exceed the maximum allowable gross weight plus 3% tolerance for scale error and the w

Free access — add to your briefcase to read the full text and ask questions with AI

(a) Violation of weight limitations.--If the gross weight or the weight upon any wheel, tire, axle or group of axles of a vehicle or combination exceeds the maximum allowed, the driver shall reduce or readjust the load so that the gross weight and the weight upon each wheel, tire, axle or group of axles will not exceed the maximum weights permitted under this chapter.

(b) Violation of size limitations.--If the load upon any vehicle or combination is such that the size limitations of this chapter are exceeded, the driver shall reduce or reposition the load so that it does not exceed the size limitations.

(c) Load adjustment to avoid prosecution.--If the gross weight of the vehicle or combination does not exceed the maximum allowable gross weight plus 3% tolerance for scale error and the weight upon any axle or group of axles is in excess of the maximum allowable axle weight, the operator shall be allowed four hours to adjust the position of the load so that the weight upon all wheels, tires, axles and groups of axles does not exceed the maximum allowable weights plus 3% tolerance for scale error as authorized in section 4981(c) (relating to weighing and measurement of vehicles). If the load is so rearranged no arrest shall be made or prosecution brought for violation of Subchapter C (relating to maximum weights of vehicles). The provisions of this subsection shall not apply to any loads which exceed the amount of weight for which a permit was issued.

(d) Load incapable of reduction.--If the load on any vehicle or combination is such that it is incapable of reduction or dismemberment and is otherwise eligible to move under permit as provided in Subchapter D (relating to special permits for excessive size and weight), a valid permit shall be obtained before any further movement of a vehicle or combination in violation of the limitations of this chapter.

(e) Responsibility of owner or driver.--All material unloaded and any vehicle or combination parked awaiting a permit shall be cared for by the owner or driver at the risk of the owner or driver.

Legislative History

(July 8, 1986, P.L.432, No.90, eff. imd.) 1986 Amendment.Act 90 amended subsec. (c). Cross References.Section 4982 is referred to in sections 4945, 4981 of this title.