Oregon § 633.331 Additional label requirements for lime products

Oregon Statutes

§ 633.331 — Additional label requirements for lime products

Oregon § 633.331

Vol.15

Title 49Food and Other Commodities

Ch. 633Grades, Standards and Labels for Feeds, Soil Enhancers and Seeds

This text of Oregon § 633.331 (Additional label requirements for lime products) is published on Counsel Stack Legal Research, covering Oregon primary law. Counsel Stack provides free access to over 12 million legal documents including statutes, case law, regulations, and constitutions.

Bluebook

Or. Rev. Stat. § 633.331 (2026).

Text

In addition to the label requirements under ORS 633.321, the label for a lime product must include the following:

(1)The name of the particular form of lime. Forms of lime may include, but are not limited to, burnt lime, dolomite, ground limestone, lime sludge, shells, sugar lime and waste lime.

(2)The guaranteed analysis, stating the following:

(a)The percentage of calcium oxide (CaO) or calcium carbonate (CaCO 3 ).

(b)The percentage of magnesium oxide (MgO) or magnesium carbonate (MgCO 3 ).

(c)The total neutralizing capacity expressed in terms of calcium carbonate equivalent (CCE).

(d)The percentage of product that will pass, respectively, a 100-mesh, 40-mesh, 20-mesh and 10-mesh sieve. The mesh size declaration may include a declaration of the percentage of product that will pass

Free access — add to your briefcase to read the full text and ask questions with AI

In addition to the label requirements under ORS 633.321, the label for a lime product must include the following:
(1) The name of the particular form of lime. Forms of lime may include, but are not limited to, burnt lime, dolomite, ground limestone, lime sludge, shells, sugar lime and waste lime.
(2) The guaranteed analysis, stating the following:
(a) The percentage of calcium oxide (CaO) or calcium carbonate (CaCO 3 ).
(b) The percentage of magnesium oxide (MgO) or magnesium carbonate (MgCO 3 ).
(c) The total neutralizing capacity expressed in terms of calcium carbonate equivalent (CCE).
(d) The percentage of product that will pass, respectively, a 100-mesh, 40-mesh, 20-mesh and 10-mesh sieve. The mesh size declaration may include a declaration of the percentage of product that will pass additional mesh sizes, but the mesh sizes specified in this paragraph must be included in the mesh size declaration.
(e) The lime score.
(f) The maximum moisture content if the moisture content is more than two percent, expressed in whole numbers as follows: “Moisture content does not exceed _____ percent.”