Young v. Randall

71 A. 647, 104 Me. 135, 1908 Me. LEXIS 48
CourtSupreme Judicial Court of Maine
DecidedApril 21, 1908
StatusPublished

This text of 71 A. 647 (Young v. Randall) is published on Counsel Stack Legal Research, covering Supreme Judicial Court of Maine primary law. Counsel Stack provides free access to over 12 million legal documents including statutes, case law, regulations, and constitutions.

Bluebook
Young v. Randall, 71 A. 647, 104 Me. 135, 1908 Me. LEXIS 48 (Me. 1908).

Opinion

Cornish, J.

Tort for personal injuries while operating a swinging circular saw in defendant’s employ. .The defendant is a manufacturer of lumber and manager of the Augusta Lumber Company, which operates a large mill at Augusta. In the spring of 1906, he purchased a lot of standing timber in the neighboring town of Belgrade and sent a crew there to cut and manufacture the same. Among them was the plaintiff who was the owner of a team of four horses and of a portable sawing machine driven by a gasoline engine. After working with his team five or six weeks yarding logs, the plaintiff started his sawing machine and with the assistance of Mr. Weston, the foreman, attempted to saw a small lot of ash logs into shovel handle bolts about forty-four inches long. This proved impracticable as the logs, varying in length from twenty-five to thirty feet, were too heavy to be handled and sawn easily with his machine which was constructed in the ordinary way for sawing cord wood, with a stationary circular saw and a push or sliding table.

The foreman then suggested the necessity of a swinging saw with a stationary table, and informed Mr. Randall through the plaintiff where a second hand machine of that sort could be obtained. Mr. Randall thereupon procured the saw and sent it, with necessary [137]*137shafting and pulleys purchased elsewhere, to Belgrade, and with it went Mr. Dixon his millwright, who was to have charge of setting it up.

The temporary machine was then hastily constructed. A table or platform about eighteen inches wide and two feet high was built of planks resting on blocking. The left end of this table, viewed from the operator who stood in front of it, was connected with a run provided with rolls over which the logs were pushed by hand lengthwise from the ground upon and along the table. Against the side of the table opposite the operator stpod three heavy logs or posts set firmly in the ground and extending above the table six or eight feet, carrying on their tops the bearings or boxes which held the main shaft. One of these posts stood within a few inches of the right end of the table, another toward the left end and eight feet from the first, and between the two was a third, the exact location of which is in controversy. At the right of this middle post and one foot from it, according to the plaintiff, or two and one-half inches from it according to the defendant, the saw frame or ladder was suspended from the main shaft in such a manner that the circular saw attached to the lower end could be swung forward and backward in the slot, extending part way across the table, by means of an oxbow bolted to the ladder and extending forward toward the operator. The distance from the saw to the right end of the table was the exact length of a bolt, forty-four inches. Four men were employed in working the machine, two at the left with cant dogs to push the logs upon the table and hold them in place, one to operate the saw, and one at the right to keep the end of the log flush with the end of the table, and to remove the bolts. In operation the logs were pushed upon the table, the larger end ahead, the scarf was first sawn off, then the various bolts and if the smaller end was less than six inches in diameter, that portion was used for cord wood.

As the saw was hung somewhat higher than the table, it had a natural tendency in cutting, to draw the logs toward and under it, a tendency which was stronger in the smaller logs, and which could be [138]*138resisted only by having proper guards and supports on the back of the table. The failure of duty alleged by the plaintiff in his writ is that the saw table "was not provided with any standards or upright pieces sufficiently near the path of said saw, so that a log or bolt could rest against the same and be held steadily in place and prevented'from swinging in upon said saw.” The plaintiff admits the existence of the three posts before described, but says they were insufficient for the purpose, as there was a space of forty-four inches at the right of the saw, and of one foot at the left without any support or guard whatever, so that in sawing a stick of such a length that it reached from the right end of the table to a point between the saw and the post on the left, it had no support whatever, except at the extreme right end, and the action of the saw tended to pull it in toward itself taking with it the hand of the operator resting upon the stick. The defendant met this issue by offering evidence tending to show that the distance from the saw to the post on the left was only two or three inches, that four or five inches at the right of the saw was an additional post firmly set in the ground and extending above the table, placed there to serve this very purpose, and also that guides or guards were attached to the back of the table, the one at the left of the saw extending from post to post, being a timber four inches square, and the one at the right, from post to post, a plank two by six set on edge. •

Here was a sharp issue of fact, the plaintiff admitting that if the fourth post and the guards were there at the time of the accident, the table was reasonably safe, and the defendant admitting that if they were not there it was negligently constructed.

The jury found for the plaintiff upon this as upon all other issues and their verdict the defendant asks to be set aside. It is unnecessary to consider the question of the defendant’s care or want of care in the construction of the machine. The plaintiff is in this dilemma. If the defendant was not guilty of negligence in this respect the plaintiff admittedly cannot recover. If the defendant was guilty of negligence the plaintiff is precluded from recovering because of his own knowledge of the careless construction and his assumption of the attendant risks. This is a fatal point in the plaintiff’s case.

[139]*139The particular danger on which he bases his right to recover was the lack of protection against the tendency of the saw to draw the logs to itself. But this was no concealed or hidden danger. It was obvious as soon as he began to operate. He felt the tendency to draw. He admits it. He saw the lack of protection, and with his experience he must or at least should have known the risk attendant upon the sawing of a stick resting against only one support. The plaintiff was not an inexperienced boy, but a man thirty years of age, of intelligence and of some experience with circular saws. He was the owner of a portable saw mill and had himself operated it six weeks or more during the previous winter, and in that time must have learned its traits. While that worked on a somewhat different plan from this, yet the difference and its effects must have been obvious to him. He had asked for no instructions before beginning work nor during its progress though Mr. Weston, the foreman, stood near by. He apparently needed none. The foreman could have told him nothing that he himself could not see and appreciate. In his writ he does not complain because no instructions were given him. Hebegan and continued the work without protest or objection, confident of his own knowledge and experience. There is evidence that he even showed impatience when cautioned more than once by the foreman not to jump the saw and not to keep his left hand upon the log. His methpd of operation was to pull the swinging saw by the oxbow with his right hand, while he steadied himself by placing his left hand upon the log at the right and within five or six inches of the saw itself.

Free access — add to your briefcase to read the full text and ask questions with AI

Related

Wilson v. Steel Edge Stamping & Retinning Co.
39 N.E. 1039 (Massachusetts Supreme Judicial Court, 1895)
Tenanty v. Boston Manufacturing Co.
49 N.E. 654 (Massachusetts Supreme Judicial Court, 1898)

Cite This Page — Counsel Stack

Bluebook (online)
71 A. 647, 104 Me. 135, 1908 Me. LEXIS 48, Counsel Stack Legal Research, https://law.counselstack.com/opinion/young-v-randall-me-1908.