Watson v. JOSLIN MILLWORK, INC.

243 P.3d 666, 149 Idaho 850, 2010 Ida. LEXIS 171
CourtIdaho Supreme Court
DecidedOctober 1, 2010
Docket37166
StatusPublished
Cited by9 cases

This text of 243 P.3d 666 (Watson v. JOSLIN MILLWORK, INC.) is published on Counsel Stack Legal Research, covering Idaho Supreme Court primary law. Counsel Stack provides free access to over 12 million legal documents including statutes, case law, regulations, and constitutions.

Bluebook
Watson v. JOSLIN MILLWORK, INC., 243 P.3d 666, 149 Idaho 850, 2010 Ida. LEXIS 171 (Idaho 2010).

Opinion

BURDICK, Justice.

This case involves an occupational disease claim that came before the Idaho Industrial Commission (Commission) at an Emergency Hearing on December 19, 2008. Appellant Robert A. Watson (Watson) alleged that his Sawyer/Assembler job with Joslin Millwork, Inc. (Joslin) (when referred to jointly, Joslin and Liberty Northwest Insurance Co. are referred to as “Respondents”) exposed him to the characteristic and peculiar hazards of repetitive heavy lifting, twisting and bending. Watson contends that his industrial exposure to the hazards of his job caused his non-acute lumbar spine occupational disease. The Commission denied his claim, finding that Watson failed to prove that his need for surgery was the result of an occupational disease arising out of, and in the course of, his employment. We affirm the decision of the Commission.

I. FACTUAL AND PROCEDURAL BACKGROUND

Watson began his employment with Joslin around September 13, 2005, at the age of 28. Prior to that time, Watson was employed as a drywall hanger for approximately nine years. In November 2007, Watson began to develop pain in his left buttocks that traveled down his left leg to his knee. Watson stated that he was not involved in any type of accident at work or outside of work prior to the onset of his symptoms. On December 12, 2007, he began seeing a chiropractor named Miles Ranck for evaluation and treat *852 ment. On the intake form that Watson filled out on his first visit to Dr. Ranck he stated that his injury had been caused by “physical labor.” After five or six sessions without improvement, Dr. Ranck referred Watson to a physiatrist, Dr. James Bates.

Watson saw Dr. Bates from January 17, 2008, until March 14, 2008. When Watson’s condition did not improve with the use of prescription medication, Dr. Bates ordered an MRI. The MRI was completed on January 23, 2008, and showed a “moderate sized left paracentral disk herniation at L5-S1 with an extruded fragment which may be a free fragment extending down into the left lateral recess dorsal to the SI vertebral body resulting in severe left lateral recess stenosis and displacement of the traversing left SI nerve root posteriorly.” Dr. Bates eventually referred Watson to a neurosurgeon, Dr. Tyler Frizzell. Watson met with Dr. Frizzell on March 6, 2008, and Dr. Frizzell concluded that Watson needed surgery.

Watson testified that he did not have any major injuries, illnesses, diseases or other problems involving his lower back when he was younger. Watson was injured in a car accident when he was 14 years old, but he did not suffer any injuries to his lower back. Watson further testified that prior to his work with Joslin he was not involved in any industrial injuries or other motor vehicle accidents and that he had absolutely no low-back problems.

Watson stated that he told his supervisor at Joslin, Brian Leisten, that he wanted to get out of the drywall business because his “elbow just couldn’t take the pressure anymore.” A letter from Leisten dated April 12, 2008, states that Watson had made comments regarding soreness in his elbow, shoulder and back, attributed to installing sheetrock. Watson denies having said this. Leisten also wrote that, near the end of 2007, Watson asked for time off due to soreness in his back and “[i]n the past, on two occasions that [Leisten was] aware of, [Watson] needed to have his back ‘popped’ by a chiropractor.”

Watson stated that, prior to going to work for Joslin he did not visit a chiropractor. However, “shortly after” Watson started working at Joslin he started seeing a chiropractor for treatment for low-back pain. The pain did not include “any symptoms that radiated from [his] low back down into [his] left buttock or left leg to the knee.” His first of two visits was on December 13, 2005. During that visit, an x-ray was taken and the chiropractor told Watson that “there was nothing wrong.” In May 2006, Watson was in a motor vehicle accident where he suffered injuries to his upper back, lower neck and shoulder. The emergency room physician determined that Watson was suffering from whiplash. Watson specifically testified that he did not suffer any injury to his lower back in that accident.

Watson described the physical demands of his job as including heavy lifting, twisting and bending. More specifically, Watson described his job as follows:

I use the forklift on the production floor to pick up a palleVunit of laminated particle board (approximately 34 sheets) and move it into position near the beam saw. After placing the pallet-unit on the floor with the forklift, I have to physically reach out away from my body with both hands/ arms and grab each individual 4X8 sheet off of the stacked pallet/unit. Each sheet weighs approximately 150 pounds. After I grab and lift the sheet, I have to twist and turn my body around approximately 180 degrees and then maneuver the sheet onto the saw and place it in the proper cutting position. I then perform cuts to specifications with the saw. After the product has been cut to specification, I will manually pick up each cut sheet and stack the individual cut sheets into a stack on the fall-off table which is attached to the saw. After I stack 4-6 individual cut pieces, I then manually grab the entire stack, lift it, turn and carry it approximately 15-20 feet where I place it on a parts’ [sic] cart. The cart has 2 shelves. The upper shelf is approximately 40 inches off of the ground and the lower shelf is approximately 10 inches off of the ground. When I slide the cut pieces into the shelves, I bend and twist at the waist in order to manipulate and position the cut product. In order to place the cut product on the lower shelf, I have to bend all the way down almost to the floor and *853 then bend over at the waist from my body. Most of the time, I have to stretch my leg out and place my right foot behind the wheel on the cart in order to prevent it from moving or slipping away during the shelving process. During a standard 8.0 hour work shift, I will lift, carry, twist, turn, bend at the waist, push and pull these laminate sheets approximately 6 out of every 8 hours of 75% to 80% of the time. As part of the production cycle, I am required to perform these physical movements repeatedly at a very fast pace (i.e., as fast as the saw will cut the product and as fast as I can move my body while lifting and carrying these heavy sheets of laminate).

Watson stated that he performed his work “as fast as the saw lets me. Usually at a moderate to fast pace.”

Dr. Frizzell sent a letter to Dr. Bates on March 6, 2008, stating that Watson had “about exhausted conservative measures,” and that he had discussed a lumbar microdiseectomy with Watson. On May 5, 2008, Dr. Frizzell sent a letter to Watson’s attorney answering “yes” to five questions pertaining to the issue of whether Watson’s disease was incurred in or arose out of and in the course of his employment with Joslin and was, in fact, a lumbar spine occupational disease.

Watson’s attorney wrote Joslin’s workers’ compensation insurance company, Liberty Northwest, a letter on May 8, 2008, putting them on notice of Watson’s occupational disease claim. In that letter, the attorney asked Liberty Northwest to authorize the L5-S1 microdiscectomy surgery recommended by Dr. Frizzell. Liberty Northwest did not respond. Liberty Northwest also failed to reply to two subsequent requests.

Free access — add to your briefcase to read the full text and ask questions with AI

Related

Charles Hartgrave v. City of Twin Falls and SIF
413 P.3d 747 (Idaho Supreme Court, 2018)
Newman K. Giles v. Eagle Farms, Inc.
339 P.3d 535 (Idaho Supreme Court, 2014)
Serrano v. Four Seasons Framing
Idaho Supreme Court, 2014

Cite This Page — Counsel Stack

Bluebook (online)
243 P.3d 666, 149 Idaho 850, 2010 Ida. LEXIS 171, Counsel Stack Legal Research, https://law.counselstack.com/opinion/watson-v-joslin-millwork-inc-idaho-2010.