Timothy R. Sherbert v. Alcan Aluminum Corporation

66 F.3d 965, 1995 U.S. App. LEXIS 27772, 1995 WL 579553
CourtCourt of Appeals for the Eighth Circuit
DecidedOctober 4, 1995
Docket95-1219
StatusPublished
Cited by23 cases

This text of 66 F.3d 965 (Timothy R. Sherbert v. Alcan Aluminum Corporation) is published on Counsel Stack Legal Research, covering Court of Appeals for the Eighth Circuit primary law. Counsel Stack provides free access to over 12 million legal documents including statutes, case law, regulations, and constitutions.

Bluebook
Timothy R. Sherbert v. Alcan Aluminum Corporation, 66 F.3d 965, 1995 U.S. App. LEXIS 27772, 1995 WL 579553 (8th Cir. 1995).

Opinion

WOLLMAN, Circuit Judge.

In this Missouri diversity action, Alcan Aluminum Corporation (Alcan) appeals the district court’s 1 denial of its posttrial motion for judgment as a matter of law or a new trial, filed after a jury found in favor of Timothy R. Sherbert on his negligence claim. Alcan appeals on the grounds that: 1) appel-lee offered no expert testimony to establish a faüure to conform to the standard of care required in forklift operation and 2) the district court wrongly refused to instruct the jury on assumption of risk. We affirm.

The underlying accident occurred on December 5, 1988, at Alcan’s metal goods division in North Kansas City, Missouri. Sherbert, a long haul truck driver employed by Roadrunner Express, a shipping company based in Albuquerque, New Mexico, delivered a shipment of aluminum to the Alcan facility. After completing the delivery, Sherbert asked Robert Edwards, an Alcan employee with eleven years of experience operating forklifts, for assistance to reposition a stack of three pallets of aluminum remaining in the rear of Sherbert’s trailer. Edwards agreed to move the stack with his forklift. While Edwards was attempting to lift the three stacked pallets, the top pañet slipped onto the ground and struck and broke Sherbert’s leg. Sherbert sued Alcan to recover damages resulting from his broken leg.

At the time of the accident, Edwards was operating a forklift designed to lift 12,000 pounds when the center of the load is positioned twenty-four inches from the back of the forks. The aluminum stack weighed no more than 6,000 pounds. The aluminum was delivered in pallets with two wooden boards called “runners” set in and attached to the underside of the pallets. These runners run lengthwise and provide additional support to lift the aluminum, which is packaged in slick waterproof paper.

The lifting process is straightforward. The forklift operator first decides how many pallets to lift in one load. These pallets are then picked up from the side by lifting the edge enough to place a wooden block under the first runner, and then maneuvering the fork underneath until it reaches the second runner. This blocking procedure may then be repeated in order to get the pallets under the second runner. Once the pallets are safely positioned on the forks, the load can be lifted.

*967 In Ms attempt to help Sherbert, Edwards followed tMs general procedure. After deciding to lift the three pallets in one load, he raised the edge of the stack, and Sherbert placed a block under the first runner. Edwards then moved the forklift underneath until the forks Mt the second runner. At this point, with the load partially onto the forks, Edwards tipped the forks back in an attempt to lift the pallets, but the weight was distributed too far out on the end of the forks, and the back wheels started to raise up. Edwards decided that to balance the load on the forklift he needed to advance the forks under the second runner.

Edwards then asked Sherbert to assist him by placing a block under the second runner. Sherbert’s first attempt failed. When Edwards lifted the pallets a second time, the top pallet slipped off the stack and Mt Sherbert, who was trapped between the sliding pallet and the wall.

Following the accident, Edwards filed a routine post-accident report. In that report, he attributed fault for the accident to his choice to move three pallets at once while Sherbert was standing in an unsafe position.

Sherbert sued Alcan in negligence to recover for his injuries. The jury returned a $45,000 verdict in favor of Sherbert, finding that Sherbert was five percent negligent and Alcan was Mnety-five percent negligent. As indicated earlier, the district court demed Alcan’s motion for judgment as a matter of law or, in the alternative, a new trial.

I. Expert Testimony

In its motion for judgment as a matter of law, Alcan argued that Sherbert failed to present a submissible ease of negligence. Specifically, Alcan argued that Sherbert failed to introduce expert testimony establishing that Edwards breached the standard of care applicable to forklift operators. According to Alcan, such evidence was indispensable because the proper operation of a forklift was not a matter within the common knowledge of lay jurors.

We review the district court’s demal of the motion for judgment as a matter of law under the same standard used by the district court. Morgan v. Arkansas Gazette, 897 F.2d 945, 948 (8th Cir.1990). We must consider the evidence in the light most favorable to the prevailing party, and affirm the demal of the motion if reasonable persons could differ as to the conclusions to be drawn from that evidence. Id. Our task is to apply tMs standard of review to determine if Sherbert produced sufficient evidence to submit the standard of care issue to the jury.

The law of Missouri governs the standard of care in tMs diversity action. See Erie Railroad Co. v. Tompkins, 304 U.S. 64, 58 S.Ct. 817, 82 L.Ed. 1188 (1938). Under Missouri law, after the court establishes the particular standard of care applicable under a given set of facts, the jury then determines whether a defendant’s conduct falls short of that standard. Harris v. Niehaus, 857 S.W.2d 222, 225 (Mo.1993) (en bane). Expert testimony is required to assist the jury in making this determination only if the subject matter is outside the knowledge or experience of lay people. Jake C. Byers, Inc. v. J.B.C. Investments, 834 S.W.2d 806, 818 (Mo. Ct.App.1992).

The operation of a forklift involves simple principles of balance well within the common knowledge of lay jurors. The jury could have based liability on at least two theories of negligence. First, the jury could have found that Edwards was negligent in lifting, three aluminum pallets in one load. In the alternative, the jury could have found that Edwards was negligent in lifting a stacked load of slick aluminum while Sherbert stood in front of the load.

Neither theory requires expert testimony. In support of the first theory, the jury heard testimony from Sherbert that Edwards had previously lifted pallets one or two at a time. In addition, Edwards testified that he attributed fault for the accident to his attempt to lift too many pallets at once while Sherbert was standing in an unsafe position. In support of the second theory, jurors could infer that tilting a 6,000 pound load of slick aluminum while a person is standing in front of that load is not reasonable behavior. The ability to draw these conclusions is well within the common knowledge of jurors.

*968 Alcan argues that expert testimony was required to explain to the jury the interrelationship of complex factors such as incline, friction and acceleration rates.

Free access — add to your briefcase to read the full text and ask questions with AI

Related

Cite This Page — Counsel Stack

Bluebook (online)
66 F.3d 965, 1995 U.S. App. LEXIS 27772, 1995 WL 579553, Counsel Stack Legal Research, https://law.counselstack.com/opinion/timothy-r-sherbert-v-alcan-aluminum-corporation-ca8-1995.