Strickland v. Martin Marietta Materials

CourtNorth Carolina Industrial Commission
DecidedJanuary 11, 2008
DocketI.C. NO. 537163.
StatusPublished

This text of Strickland v. Martin Marietta Materials (Strickland v. Martin Marietta Materials) is published on Counsel Stack Legal Research, covering North Carolina Industrial Commission primary law. Counsel Stack provides free access to over 12 million legal documents including statutes, case law, regulations, and constitutions.

Bluebook
Strickland v. Martin Marietta Materials, (N.C. Super. Ct. 2008).

Opinion

* * * * * * * * * * *
Following reconsideration of the prior Opinion and Award of the Full Commission, and upon review of the competent evidence of record with reference to the errors assigned, finding no good grounds to receive further evidence or to rehear the parties or their representatives, the Full Commission upon reconsideration of the evidence reverses the Opinion and Award of the Deputy Commissioner.

* * * * * * * * * * * *Page 2
ADDITIONAL EVIDENCE
The Full Commission reopens the record of evidence and admits as evidence pursuant to Rule 701(6) of the Workers' Compensation Rules of the North Carolina Industrial Commission the following:

1. The affidavits and exhibits attached to Defendants' October 1, 2007, Motion to Reconsider the Decision of the Opinion and Award of the Full Commission Filed September 7, 2007; and

2. The affidavit and exhibits attached to Plaintiff's October 15, 2007, Response to Defendants' Motion for Reconsideration.

* * * * * * * * * * *
The Full Commission finds as fact and concludes as matters of law the following, which were entered into by the parties at the hearing as:

STIPULATIONS
1. At all times relevant to this claim, the parties were subject to and bound by the provisions of the North Carolina Workers' Compensation Act.

2. At all times relevant to this claim, an employment relationship existed between Plaintiff and Defendant-Employer.

3. On March 24, 2005, Specialty Risk Services was the workers' compensation carrier for Defendant-Employer.

4. The parties stipulated that Plaintiff's average weekly wage was $769.00, yielding a compensation rate of $512.66.

5. The short-term disability payments received by Plaintiff following his June 22, 2005, shoulder surgery were paid out of a benefits fund funded solely by Defendant-Employer. *Page 3

* * * * * * * * * * *
ISSUES
1 Did Plaintiff sustain an injury by accident on March 24, 2005, which resulted in a rotator cuff tear to his right shoulder?

2. What benefits, if any, is Plaintiff entitled to recover pursuant to the North Carolina Workers' Compensation Act?

3. Is Plaintiff's attorney entitled to attorney fees for litigating the issues set forth pursuant to N.C. Gen. Stat. § 97-88.1?

* * * * * * * * * * *
Based upon the competent evidence of record, the Full Commission makes the following:

FINDINGS OF FACT
1. At the time of hearing before the Deputy Commissioner, Plaintiff was 53 years of age, having a date of birth of July 3, 1952. As of March 24, 2005, Plaintiff had worked for Defendant-Employer's rock quarry business for over twenty years. Defendant-Employer's rock quarry business involved drilling, blasting, crushing, and processing stone to sell for concrete and asphalt. Plaintiff was employed with Defendant-Employer as a lead person, which is a management position that Plaintiff had held for approximately ten years.

2. The position as a lead person required Plaintiff to supervise thirteen employees and oversee all quarry operations, including maintenance, drilling, and blasting operations. Additionally, Plaintiff's position required him to use shovels, coffin hoists, and chains; operate all quarry equipment; and drive loaders and perform any other duties that needed to be done at the quarry. Plaintiff testified that his job was eighty percent labor and twenty percent management. *Page 4

3. On March 24, 2005, Defendant-Employer's Kings Mountain Quarry was having a problem with the engine door of a Volvo rock loader used in the quarry operations. The door to the engine compartment was bent and would not properly close. The door was located on the front, right side of the loader. A metal platform measuring two feet by two feet was located below and to the right of the engine compartment door. The platform was three feet off the ground.

4. On March 24, 2005, Plaintiff sustained an injury to his right shoulder while repairing the bent engine compartment door on the Volvo loader. On that date, Steve Hullender, a foreman, and Randy Cogdell, a welder, determined that the loader door needed repair to enable it to close properly. Mr. Hullender, Mr. Cogdell, and Plaintiff began working to straighten the door. The Plant Manager, Don Champion, was present at the beginning of the repair, but did not stay until the work was completed.

5. The engine compartment loader door was straightened using a thirty-pound coffin hoist (also referred to as a "comealong"), a chain, and a four by four board. Mr. Cogdell testified that he had never seen the door repaired in this manner before and that he had never seen Plaintiff perform repair work on a loader's engine compartment door before. Mr. Hullender climbed on top of the loader's tire and braced the four by four board behind the engine compartment door to keep it in a fixed position. Mr. Cogdell brought the chain and coffin hoist to the loader. Plaintiff stood on the two feet by two feet platform and connected the coffin hoist to a hook inside the engine compartment of the Volvo loader. Plaintiff wrapped the chain, which he connected to the coffin hoist, around the door and hooked the chain to the door. Plaintiff then placed his right hand on the handle of the coffin hoist, which was about chest high, and began to ratchet or "jack" the coffin hoist to tighten the chain and exert pressure to straighten the bent *Page 5 door. Due to the tight space, Plaintiff leaned back against the battery box to ratchet or "jack the comealong."

6. Plaintiff's body was in an awkward position while performing the repair work. He was working in a confined space, on the two feet by two feet platform which was three feet off the ground, and he had to lean at an angle against the battery box and reach chest-high to ratchet the coffin hoist. Due to his body weight of approximately 242 pounds, the size and position of the platform, and his fear of falling, Plaintiff could not face the engine door "straight on." He worked from the platform for as much as 45 minutes without a break and testified that he became tired. Plaintiff had never repaired an engine door before and had never used a coffin hoist in the manner and under the circumstances in which he worked on March 24, 2005.

7. When the straightening of the door was completed, Plaintiff proceeded to remove the coffin hoist from the engine compartment hook. He testified that he "tripped the lever to release the comealong and jack it back" and unhooked the chain from the door. Plaintiff then placed his left hand on the engine door to steady himself to keep from falling and, while leaning at an angle, used his right hand to grab the handle of the coffin hoist and reach in an upward motion to "snatch" and clear the coffin hoist from the engine compartment hook. Plaintiff testified that he immediately felt a "loud pop" in his right arm and sharp pain through his upper shoulder causing him to then grab the coffin hoist with his left hand because he did not want it to fall into the engine compartment. Plaintiff testified that he would not have tried to move the coffin hoist from the hook with one hand had he not been working in such a confined space up off the ground.

Free access — add to your briefcase to read the full text and ask questions with AI

Related

Calderwood v. Charlotte-Mecklenburg Hospital Authority
519 S.E.2d 61 (Court of Appeals of North Carolina, 1999)
Russell v. Lowes Product Distribution
425 S.E.2d 454 (Court of Appeals of North Carolina, 1993)
Adams v. Burlington Industries, Inc.
300 S.E.2d 455 (Court of Appeals of North Carolina, 1983)
Griggs v. Eastern Omni Constructors
581 S.E.2d 138 (Court of Appeals of North Carolina, 2003)
Church v. Baxter Travenol Laboratories, Inc.
409 S.E.2d 715 (Court of Appeals of North Carolina, 1991)

Cite This Page — Counsel Stack

Bluebook (online)
Strickland v. Martin Marietta Materials, Counsel Stack Legal Research, https://law.counselstack.com/opinion/strickland-v-martin-marietta-materials-ncworkcompcom-2008.