Norman v. Maxon Furniture

CourtNorth Carolina Industrial Commission
DecidedFebruary 1, 2008
DocketI.C. No. 439708.
StatusPublished

This text of Norman v. Maxon Furniture (Norman v. Maxon Furniture) is published on Counsel Stack Legal Research, covering North Carolina Industrial Commission primary law. Counsel Stack provides free access to over 12 million legal documents including statutes, case law, regulations, and constitutions.

Bluebook
Norman v. Maxon Furniture, (N.C. Super. Ct. 2008).

Opinion

***********
The undersigned reviewed the prior Opinion and Award based upon the record of the proceedings before Deputy Commissioner Ledford. The appealing party has not shown good ground to reconsider the evidence, receive further evidence, rehear the parties or their representatives, and having reviewed the competent evidence of record, the Full Commission affirms the Opinion and Award of Deputy Commissioner Ledford with minor modifications.

***********
The Full Commission finds as fact and concludes as matters of law the following, which were entered into by the parties at the hearing before the Deputy Commissioner as:

STIPULATIONS
1. The parties are subject to and bound by the provisions of the North Carolina Workers' Compensation Act. *Page 2

2. At all relevant times, the Plaintiff was an employee of Defendant-Employer.

3. The carrier on the risk is AIG Claim Services, Inc.

4. Plaintiff's average weekly wage is $579.44, which yields a compensation rate of $386.31.

5. Plaintiff claims to have received short-term disability benefits totaling $1,318.77. Defendants dispute this amount.

6. Plaintiff continues to work for Defendant-Employer at his pre-injury job duties.

7. Commission Proceedings consisting of 9 pages were received into evidence as Stipulated Exhibit 1.

8. Plaintiff's medical records consisting of 28 pages were received into evidence as Stipulated Exhibit 2.

***********
Based upon all of the competent evidence of record and reasonable inferences flowing therefrom, the Full Commission makes the following:

FINDINGS OF FACT
1. At the time of the hearing before the Deputy Commissioner, plaintiff was fifty-one (51) years of age, with a date of birth of October 31, 2954. Plaintiff has a high school education and special skills or training. The majority of plaintiff's work experience has been in the furniture manufacturing industry. Plaintiff began working for defendant-employer as an "assembler" on November 18, 2002.

2. Prior to his employment with defendant-employer, plaintiff worked for Baker Furniture for approximately twenty-one (21) years. *Page 3

During his employment with Baker Furniture, plaintiff assisted in the construction of end tables, cocktail tables, and dining tables. During his employment, plaintiff developed bilateral injury to his hands and elbows. He underwent surgeries and filed a workers' compensation claim for those injuries. Plaintiff received a permanent partial impairment rating of nineteen percent (19%) to his left arm and twenty percent (20%) to his right hand and the claim was settled.

3. Plaintiff described his job duties as defendant-employer as requiring frequent and repetitive use of his hands and arms all workday long to handle tabletops. Plaintiff would frequently extend his arms out away from his body in order to lift, carry, pull, flip and push the tabletops. Plaintiff estimates that he spent at least an hour total each workday since November 18, 2002 until approximately March 2004 using his left hand at or above eye level to lift, carry, pull, flip or push the tabletops. The tabletops plaintiff handled varied in weight and physical dimension.

4. From November 2002 through October 2003, plaintiff worked about seven hours per day, five days a week, lifting tabletops weighing ten to one hundred pounds and placing them into cardboard cartons, at a rate of about thirty per hour.

5. From November 2003 to March 2004, plaintiff performed three different primary tasks as follows:

a. Three mill (cover tabletop edges): Plaintiff would stand using his hands and arms to lift tabletops weighing ten to one hundred pounds into position so a machine could put a coating on the sides of the tops' edges. Plaintiff would use his arms to exert force to hold the tabletop in place.

b. Vinyl cover on tabletops and edges: Plaintiff would lift each top and place it flat on the table, then use a glue gun to spray glue on the tops. He would then put vinyl on the tabletop. *Page 4

c. T-Mold (plastic or rubber edge banding around top edges): Plaintiff would lift and carry the tabletop to the T-mold table. Plaintiff would push the tabletop against a round cylinder that vibrates to force the T-mold in groove on the edge of the tabletop.

6. The Full Commission finds plaintiff's description of his job duties accurate and credible.

7. About January 2004, plaintiff developed left shoulder pain, which gradually grew worse. In March 2004, plaintiff saw his family physician, complaining of left shoulder pain. Plaintiff's family physician referred him to Dr. Michael King, an orthopedic specialist in Winston-Salem, for evaluation.

8. Dr. King examined Plaintiff on April 8, 2004. Plaintiff described the work he was doing at the time and told Dr. King that his work made his left shoulder pain worse. Dr. King diagnosed probable superior labrum anterior posterior (SLAP) lesion, AC joint osteolysis and synovitis, biceps tendonitis and left shoulder impingement syndrome. Dr. King ordered an MRI and arthrogram.

9. On April 9, 2004, Plaintiff reported to his supervisor that he was experiencing left shoulder pain, which he believed was due to his job duties. A Supervisor's Report of Accident/Injury or Near Miss was completed that same day.

10. On April 29, 2004, Plaintiff returned to see Dr. King. At that time, Dr. King interpreted plaintiff's left shoulder MRI and arthrogram results, which confirmed his prior assessment of left shoulder impingement syndrome and also showed a partial tear of the rotator cuff and SLAP lesion. Dr. King recommended left shoulder arthroscopic surgery. *Page 5

11. Plaintiff continued working for the defendant-employer until undergoing left shoulder surgery. On July 13, 2004 Dr. King performed left shoulder arthroscopic subacromial decompression surgery with a post-surgical diagnosis of left shoulder impingement syndrome.

12. On August 23, 2004, plaintiff returned to lighter duty work with defendant-employer for approximately thirty days. After that he returned to his regular duties.

13. As assessed by Dr. King, by May 5, 2005, plaintiff reached maximum medical improvement from his left shoulder impingement syndrome condition. Plaintiff retained a ten percent (10%) permanent partial impairment to his left arm as a result of his left shoulder impingement syndrome condition.

14. Dr. King opined, and the Full Commission finds, that plaintiff was placed at an increased or greater risk of developing left shoulder impingement syndrome as a result of his job duties for defendant-employer as a furniture assembler than members of the general public or employees, in general, not equally exposed.

15. Dr. King further opined, and the Full Commission finds, that plaintiff's work duties with the defendant-employer significantly contributed to the development of plaintiff's left shoulder impingement syndrome condition.

16. The greater weight of the competent evidence of record shows that as a result of plaintiff's repetitive use of his left upper extremity to perform his job duties for defendant-employer, plaintiff by early 2004 developed the occupational disease of left shoulder impingement syndrome arising out of and in the course of his employment.

17.

Free access — add to your briefcase to read the full text and ask questions with AI

Related

§ 97-2
North Carolina § 97-2(19)
§ 97-29
North Carolina § 97-29
§ 97-31
North Carolina § 97-31(13)
§ 97-42
North Carolina § 97-42
§ 97-53
North Carolina § 97-53(13)
§ 97-88.1
North Carolina § 97-88.1

Cite This Page — Counsel Stack

Bluebook (online)
Norman v. Maxon Furniture, Counsel Stack Legal Research, https://law.counselstack.com/opinion/norman-v-maxon-furniture-ncworkcompcom-2008.