Frederick v. Goff

100 N.W.2d 624, 251 Iowa 290, 1960 Iowa Sup. LEXIS 605
CourtSupreme Court of Iowa
DecidedJanuary 12, 1960
Docket49867
StatusPublished
Cited by51 cases

This text of 100 N.W.2d 624 (Frederick v. Goff) is published on Counsel Stack Legal Research, covering Supreme Court of Iowa primary law. Counsel Stack provides free access to over 12 million legal documents including statutes, case law, regulations, and constitutions.

Bluebook
Frederick v. Goff, 100 N.W.2d 624, 251 Iowa 290, 1960 Iowa Sup. LEXIS 605 (iowa 1960).

Opinion

Garfield, J.

Plaintiff, Frederick, was severely injured in the course of his employment as a farm hand for defendant, Goff. In this law action plaintiff alleges the injury was caused by defendant’s negligence in providing defective equipment for plaintiff to work with. Trial resulted in a jury verdict for plaintiff upon which judgment was entered.

Defendant-appellant’s sole contention here is that he was entitled to a directed verdict and judgment notwithstanding the jury verdict for three basic reasons: (1) There is no evidence of defendant’s negligence; (2) the alleged negligence was not the proximate cause of the injury; (3) plaintiff assumed the risk. We will consider these grounds in this order: the first, the third and, finally, the second. We will first refer to the essential evidence. In accordance with our duty, it will be viewed in the light most favorable to plaintiff.

Plaintiff, a married man then 28, was injured Monday morning, July 15, 1957, while filling defendant’s silo with oats ensilage. He had worked on defendant’s farm since June 3, 1956. The equipment with which plaintiff was working was put in place during the preceding week by plaintiff and another employee, Randy Enger, under defendant’s supervision. The wagonload of ensilage which was being blown into the silo when plaintiff was injured was put in place adjoining the ensilage blower the preceding Saturday. Plaintiff was working alone when injured. The equipment in use consisted of an ensilage blower, a self-unloading wagon which dumped the ensilage into the hopper of the blower, and two tractors which generated the power. One tractor supplied power to the blower, the other the power to move the false endgate and ensilage from the front of the wagon to its rear where it fell into the hopper of the blower.

*293 The ensilage blower consisted of a hopper eight feet long, an auger at the bottom of the hopper by which ensilage was moved toward the fan and the fan that blew the ensilage up through a pipe extending to the top of the silo. We set out here a reproduction of an exhibit showing the ensilage blower.

Bottom of the pipe leading to the top of the silo was affixed to the top of the inverted funnel-shaped device at the upper left of the fan. The U-shaped rod at the fan end of the hopper, just below the name “Gehl”, is the lever which starts and stops the auger. The lever is pulled toward the hopper to start the auger and pushed back against the fan to stop it. The rear of the wag'on, eight feet wide, filled with ensilage was backed against the reader’s right side of the hopper. Plaintiff was standing on the left, south, side of the hopper. The silo was on his *294 left, west — at the fan end of the blower. Defendant had directed plaintiff to unload the wagon filled with ensilage and to hurry-in doing it so he could work in the field.

Shortly before plaintiff was injured the pipe leading to the top of the silo had become loose and turned out of position. Randy Enger had put up the pipe. Plaintiff stood on the left, south, edge or lip of the hopper, reached up and tightened the pipe with his hands. It could not be tightened readily while standing on the ground because the necessary leverage could not be applied from such position. When the blower was in use the pipe would turn several times a day and had to be tightened. Defendant himself had tightened the pipe while standing on top of the housing which enclosed the fan.

At about the time the pipe to the silo turned out of position the power which operated the unloading device on the wagon ceased to function when the knuckle came off the splined (grooved) end of the shaft on the power take-off. These two parts were worn, did not fit together properly and had become disconnected on several prior occasions, including three or four times while the same load was being unloaded that morning. The previous week these parts had slipped off about once to each load of ensilage put into the silo.

After turning the pipe into place plaintiff picked up the shaft that had fallen off and put it back in place but he could not connect the two grooved ends without driving them together with a bar. He then stepped down from the edge of the hopper to get a bar hanging on the silo to use for this purpose. After picking up the bar he stepped back onto the edge of the hopper with his right foot so he could drive the knuckle on to the end of the shaft that supplied power for unloading the wagon. He reached up for the endgate of the wagon, which was over the hopper, to pull himself upright onto its edge, when his right foot slipped into the hopper, fell against the auger and was propelled by it into the fan. In falling, his left hand inadvertently came in contact with the lever (before referred to) which started the auger moving. Within three or four seconds plaintiff was able to push the lever back against the fan and thus stop the auger. However the foot had already been injured.

*295 Plaintiff could not put the disconnected knuckle back on the shaft while standing on the ground at the operator’s side of the blower. On the three or four previous occasions that morning when the knuckle slipped off the shaft, plaintiff walked to his right around the wagon, climbed a board fence 4% to 5 feet high and walked back between the wagon and silo to the power shaft. It took him about five minutes to do this and replace the shaft and knuckle. There was not more than three feet of clearance between the drive belt and the wagon where plaintiff walked. On these prior occasions he did not shut off the motor in the tractor (which would have stopped the drive belt from revolving) because the starter on the tractor was not working. To start the motor it was necessary “to short it out with a wrench onto the terminals to make contact with the starter.”

Plaiutiff had been working at this task about 45 minutes that morning and about a third of the load was unloaded when he was injured. When there were no stoppages a load of ensilage could be blown into the silo in 15 to 20 minutes. The added time on this occasion was mainly due to interruption of the power for the unloading device on the wagon when the knuckle slipped off the shaft and the time necessary to replace it.

Defendant was fully aware of the worn condition of the knuckle and splined end of the shaft. When the two parts became disengaged while in operation the grooves would be “jimmed” and had to be filed down before they could be put back together in working order. This occurred several times before the morning in question. Referring to these worn parts the week before plaintiff’s injury, defendant had said, “ We would have to see about fixing it — it should be fixed.’ ”

I. Defendant’s negligence. It is a settled rule that an employer must use reasonable care to provide and maintain for his employees reasonably suitable and safe appliances, machinery and tools with which to work. Von Tersch v. Ahrendsen, 251 Iowa 115, 118, 119, 99 N.W.2d 287, 289, and citations; Degner v. Anderson, 213 Iowa 588, 589, 239 N.W. 790; Swaim v. Chicago, R. I. & P. Ry. Co., 187 Iowa 466, 477, 174 N.W. 384; 56 C. J. S., Master and Servant, sections 201, 206.

Free access — add to your briefcase to read the full text and ask questions with AI

Related

Gerst v. Marshall
549 N.W.2d 810 (Supreme Court of Iowa, 1996)
Waitek v. Dalkon Shield Trust
908 F. Supp. 672 (N.D. Iowa, 1995)
Aetna Casualty & Surety Co. v. Leo A. Daly Co.
870 F. Supp. 925 (S.D. Iowa, 1994)
Sumpter v. City of Moulton
519 N.W.2d 427 (Court of Appeals of Iowa, 1994)
State v. Marti
290 N.W.2d 570 (Supreme Court of Iowa, 1980)
Lewis v. State
256 N.W.2d 181 (Supreme Court of Iowa, 1977)
Dickman v. Truck Transport, Inc.
224 N.W.2d 459 (Supreme Court of Iowa, 1974)
Bickford v. American Interinsurance Exchange
224 N.W.2d 450 (Supreme Court of Iowa, 1974)
Gunnison v. Torrey
216 N.W.2d 361 (Supreme Court of Iowa, 1974)
Winter v. Honeggers'& Co., Inc.
215 N.W.2d 316 (Supreme Court of Iowa, 1974)
Olson v. Katz
201 N.W.2d 478 (Supreme Court of Iowa, 1972)
Ackerman Ex Rel. Ackerman v. James
200 N.W.2d 818 (Supreme Court of Iowa, 1972)
Dobson v. Jewell
189 N.W.2d 547 (Supreme Court of Iowa, 1971)
Schmitt v. Jenkins Truck Lines, Inc.
170 N.W.2d 632 (Supreme Court of Iowa, 1969)
Miller v. Young
168 N.W.2d 45 (Supreme Court of Iowa, 1969)
Hedges v. Conder
166 N.W.2d 844 (Supreme Court of Iowa, 1969)
Van Aernam v. Nielsen
157 N.W.2d 138 (Supreme Court of Iowa, 1968)
Bengford Ex Rel. Bengford v. Carlem Corp.
156 N.W.2d 855 (Supreme Court of Iowa, 1968)
Knudtson v. Swenson
155 N.W.2d 756 (Supreme Court of Iowa, 1968)

Cite This Page — Counsel Stack

Bluebook (online)
100 N.W.2d 624, 251 Iowa 290, 1960 Iowa Sup. LEXIS 605, Counsel Stack Legal Research, https://law.counselstack.com/opinion/frederick-v-goff-iowa-1960.