Byrne v. Learnard

77 N.E. 316, 191 Mass. 269, 1906 Mass. LEXIS 1262
CourtMassachusetts Supreme Judicial Court
DecidedMarch 7, 1906
StatusPublished
Cited by10 cases

This text of 77 N.E. 316 (Byrne v. Learnard) is published on Counsel Stack Legal Research, covering Massachusetts Supreme Judicial Court primary law. Counsel Stack provides free access to over 12 million legal documents including statutes, case law, regulations, and constitutions.

Bluebook
Byrne v. Learnard, 77 N.E. 316, 191 Mass. 269, 1906 Mass. LEXIS 1262 (Mass. 1906).

Opinion

Sheldon, J.

This is' an action of tort under E. L. c. 106, § 71, with a count at common law, to recover for injuries sustained by the plaintiff while in the employ of the defendants and at work feeding fat or suet into a chopping machine called a hasher in their building at the abbatoir in Brighton. Proper notice had been given to the defendants, and no question is raised as to this or as to the pleadings.

The plaintiff came to this country from Ireland on May 6, 1901. He had worked on a farm, but never on machinery. On May 13,1901, he went to work for the defendants at their abbatoir. Here he was employed for two weeks in the cellar, wheeling fat on trucks, loading and unloading teams, and whitewashing. At the beginning of the third week, Hapgood, the defendants’ superintendent, told him that at noon of the next day he would put him at work on the hasher; and the plaintiff went to work on this machine the following day at noon.

One working on this machine stood at a bench or table, which was three and a half feet above the floor. At one end of this bench there was a hole eight or ten inches in diameter, opening into the hasher by a tunnel shaped receptacle, the top of which was flush with the top of the table and of the same diameter as the hole itself, and which tapered downward into one end of an iron cylinder box. This box contained a shaft running longitudinally with the box and extending entirely across the bottom of the tunnel, set with knives put on spirally so as to form a worm or screw. This shaft was attached to a fast and loose pulley operated by steam power, so that when the machine was running it made six hundred or seven hundred revolutions a minute. The diameter of the tunnel at its bottom where the knives revolved was five or six inches, and the distance from the opening in the bench to the top of the knives was about eight inches. The cylinder box was about twenty-four inches long and eight or ten inches square, and wholly encased the knives [272]*272and revolving shaft, so that these were not visible except through the mouth of the tunnel when empty. Besides the spiral knives, there were other knives fixed on the inside of the cylinder, and the fat was cut up between the two sets.of knives as it was forced through the cylinder by the action of the spiral knives.

The machine was placed on a platform or staging midway between the third and fourth floors of the building. The suet and fat to be hashed were brought up from the basement on an elevator, and placed on the table at the right hand of the man feeding the machine, and by him pushed along the table by hand into the mouth of the tunnel. After passing through the cylinder, the material came out at the other end a pulpy mass, and passed through a chute into a kettle on the floor below. All the mechanism was below the table and out of sight of the operator.

When the plaintiff went to work on this machine at noon, he found a man named Duggan at work upon it, and watched him for a second or two until he stepped one side, and then the plaintiff began to put the fat through the hole with both hands, as he had seen Duggan do, and continued this work for an hour, when Duggan returned. About a week afterwards, the plaintiff again worked on this machine in the same way for something less than an hour, while Duggan was away. On this occasion, while the plaintiff was working, as he testified, Hapgood came towards him, on the floor beneath the platform on which the machine stood, and made motions with his hands to indicate that the plaintiff should use both his hands in pressing the fat into the tunnel, and told him to do it in that way, and to put the fat through quicker, to “ press right tight into the machine with both hands ”; and the plaintiff did so, pressing it tight into the machine with both hands, while Hapgood stood there watching him.

The third time, on June 17 in the same year, while the plaintiff was loading fat into a truck, Hapgood said to him, “ Patrick, you go to your dinner at eleven o’clock and come back at twelve and go on to the hasher.” The plaintiff did so, and worked until one o’clock, when Duggan came back and began to do the plaintiff’s regular work, and the plaintiff continued to work on this machine. He testified that he went on doing .the work as Hap-[273]*273good had instructed him, pressing the fat tight into the machine with both hands, for three quarters of an hour longer; and then, while he was pressing it tight into the mouth of the tunnel, the fat went off in a plunge from his hand, and took his right hand into the machine with it and his arm was taken off below the elbow. He testified that he was doing the work in the only-way that had been shown him; that he did not know how the machine was operated, that he did not understand it, and never had seen it standing still; that it was operated by pulleys, and he had nothing to do with the operation ; that the mouth of the machine was always covered with fat when he saw it, and he never had seen what was in the opening; that he never had seen anything like a wooden pounder used to press the fat in; that he did not know that there was anything inside the machine that chewed up the fat, although he knew that the fat came out softer after passing through the machine. He also testified, on cross-examination, that on the day he was hurt he knew that it was Duggan’s duty to run the machine until twelve o’clock, and the plaintiff’s business to run it then until one o’clock, and then it was Duggan’s business to go on with it again, so that it was not part of the plaintiff’s work to run it at the time he was hurt; and that he was supposed to leave it at one o’clock and go back into the basement.

One Fairbairn, a mechanical engineer, described this machine and its operation substantially as already stated, and said that it was similar to the domestic machines used in families for making mincemeat; that when it was in operation a man could not tell anything about the internal parts of it; that the knives made between six hundred and seven hundred revolutions a minute, and at that speed could not be readily distinguishable as separate knives ; that the worm for pushing the fat along extended under the entire opening at the bottom of the tunnel; that all that any one could see, when looking down into the tunnel, if there was no fat to obstruct the view, was the part of the knives that went across the five or six inch circle at the bottom of the tunnel; that the worm is visible through the tunnel if empty when the machine is still, but when it is in motion, one looking in when there was no fat to obstruct his view, would see only the whirl of revolving machinery.

[274]*274One Griffin, a carpenter, testified that he built the floor under this machine, and helped make the bench that the fat was laid on; that the bench was composed of a board with just enough of a railing to keep the fat on, an inch or an inch and a half high; that the man who was feeding the machine used both hands to push the fat along the bench into the hole, and kept feeding the machine, using both hands.

At the end of the plaintiff’s evidence, the material parts of which have now been stated, the judge who presided at the trial ordered a verdict for the defendants; and the case comes before us upon the plaintiff’s exceptions to his ruling.

The defendants contend that the case comes within the rule 'laid down in Chmiel v. Thorndike Co. 182 Mass. 112; Sullivan v. Simplex Electrical Co. 178 Mass. 35 ; Robinska v. Lyman Mills, 174 Mass. 432; and Stuart v.

Free access — add to your briefcase to read the full text and ask questions with AI

Related

Enga v. Sparks
51 N.E.2d 984 (Massachusetts Supreme Judicial Court, 1943)
Cary v. Streeter & Sons Co.
169 N.E. 782 (Massachusetts Supreme Judicial Court, 1930)
Comparone v. Stillwater Worsted Co.
94 A. 878 (Supreme Court of Rhode Island, 1915)
Lavartue v. Ely Lumber Co.
99 N.E. 469 (Massachusetts Supreme Judicial Court, 1912)
Cote v. D. W. Pingree Co.
91 N.E. 300 (Massachusetts Supreme Judicial Court, 1910)
Ruddy v. George F. Blake Manufacturing Co.
91 N.E. 310 (Massachusetts Supreme Judicial Court, 1910)
Halley v. Nashua River Paper Co.
88 N.E. 761 (Massachusetts Supreme Judicial Court, 1909)
Donovan v. Chase Shawmut Co.
87 N.E. 580 (Massachusetts Supreme Judicial Court, 1909)
Lewis v. Coupe
85 N.E. 1053 (Massachusetts Supreme Judicial Court, 1908)
Boyd v. Taylor
81 N.E. 277 (Massachusetts Supreme Judicial Court, 1907)

Cite This Page — Counsel Stack

Bluebook (online)
77 N.E. 316, 191 Mass. 269, 1906 Mass. LEXIS 1262, Counsel Stack Legal Research, https://law.counselstack.com/opinion/byrne-v-learnard-mass-1906.