American Motors Corp. v. Blum

603 F.2d 978, 195 U.S. App. D.C. 396, 13 ERC 1412
CourtCourt of Appeals for the D.C. Circuit
DecidedJuly 20, 1979
DocketNo. 78-1799
StatusPublished
Cited by4 cases

This text of 603 F.2d 978 (American Motors Corp. v. Blum) is published on Counsel Stack Legal Research, covering Court of Appeals for the D.C. Circuit primary law. Counsel Stack provides free access to over 12 million legal documents including statutes, case law, regulations, and constitutions.

Bluebook
American Motors Corp. v. Blum, 603 F.2d 978, 195 U.S. App. D.C. 396, 13 ERC 1412 (D.C. Cir. 1979).

Opinion

Opinion for the court filed by Circuit Judge ROBB.

ROBB, Circuit Judge:

In this case American Motors Corporation (AMC) attacks a decision by the Administrator of the Environmental Protection Agency which permits the State of California to apply to AMC motor vehicle emission standards more strict than the federal standards promulgated under the Clean Air Act. 42 U.S.C. § 7401 et seq. Specifically AMC complains that the California standards permitted by the Administrator deny to AMC the “lead time” mandated by Congress in section 202(b)(1)(B), 42 U.S.C. § 7521(b)(1)(B). We conclude that the Administrator’s order must be reversed.

Section 202(a)(1) of the Act directs the Administrator by regulation to prescribe automotive emission standards. Section 202(a)(2) provides that “Any regulation prescribed under paragraph (1) . . . shall take effect after such period as the Administrator finds necessary to permit the development and application of the requisite technology, giving appropriate consideration to the cost of compliance within such period.” Section 202(b)(1)(B) provides:

(B) The regulations under subsection (a) of this section applicable to emissions of oxides of nitrogen from light-duty vehicles and engines manufactured during model years 1977 through 1980 shall contain standards which provide that such emissions from such vehicles and engines may not exceed 2.0 grams per vehicle mile. The regulations under subsection (a) of this section applicable to emissions of oxides of nitrogen from light-duty vehicles and engines manufactured during the model year 1981 and thereafter shall contain standards which provide that such emissions from such vehicles and engines may not exceed 1.0 gram per vehicle mile. The Administrator shall prescribe standards in lieu of those required by the preceding sentence, which provide that emissions of oxides of nitrogen may not exceed 2.0 grams per vehicle mile for any light-duty vehicle manufactured during model years 1981 and 1982 by any manufacturer whose production, by corporate identity, for calendar year 1976 was less than three hundred thousand light-duty motor vehicles worldwide if the Administrator determines that—
(i) the ability of such manufacturer to meet emission standards in the 1975 and subsequent model years was, and is, primarily dependent upon technology developed by other manufacturers and purchased from such manufacturers; and
(ii) such manufacturer lacks the financial resources and technological ability to develop such technology. (Emphasis added)

The legislative history discloses that the purpose of the provision in section 202(b)(1)(B) for “standards in lieu of those required by the preceding sentence” was to provide additional “lead time” to small producers who are dependent upon others for necessary technology. The three principal automotive emissions are hydro carbons (HC), carbon monoxide (CO), and nitrogen oxides (NOx). Control of these emissions is achieved by catalytic converters designed to operate simultaneously on all three emissions. The converters are complex electronic devices and their design and development require extensive research, specialized laboratories and highly trained scientists and technicians. Small companies such as AMC [398]*398that do not have the capacity or facilities for this work are required to buy pollution control devices from other manufacturers. This dependence upon others means that small manufacturers lag behind larger companies in receiving the benefits of the latest technology; they must wait until hardware has been developed and tested by others and must then adapt it to their own vehicles.

The language in section 202(b)(1)(B), relating to small manufacturers, was contained in an amendment sponsored by Senator Nelson. He stated that he understood his amendment would cover only AMC and another small manufacturer, Avanti. 123 Cong.Rec. S9233 (daily ed. June 9, 1977). He explained the purpose of the provision:

It is agreed by everyone without any exception that I know of, that American Motors has a special problem because, unlike the big three automakers, it does not design and build its own' pollution control systems. It must purchase this technology from General Motors, Ford, or Chrysler.
Once it has purchased the technology it must modify and adapt the system to its own product line. This requires between 1 and 2 years.
Consequently, American Motors Corp. is unavoidably behind in the pollution abatement timetable from the very beginning. Therefore, since American Motors lacks the electronic control engineering expertise, it should not be and cannot be expected to comply with the same timetable established for the three major manufacturers.

123 Cong.Rec. S9231 (daily ed. June 9, 1977) (Emphasis added).

Senator Nelson emphasized that AMC’s problem is particularly acute because meeting a 1.0 or less NOx standard requires new three-way catalytic converter technology:

To meet these numbers, new basic power-plant control systems with onboard computer-like electronic controls must be used. To go to these lower numbers the company must purchase total systems control, not just individual components. AMC will have to aline [sic] itself, on a long-term basis, with one of the major manufacturers and then adapt its pollution abatement system to AMC’s product line.

Id., p. S9232.

Finally, the Senator stated that AMC needed at least two years of lead time in addition to that allowed the rest of the industry “to develop adequate experience with and confidence in the advanced systems of technology that would be necessary.” Id.

The EPA supported the low volume manufacturer exception proposed by Senator Nelson. Thus on the day the Nelson amendment was introduced in the Senate the Administrator wrote to the Senator acknowledging AMC’s need for extra lead time. The Administrator stated:

The 1.0 gram/mile standard creates an additional problem peculiar to AMC and other small manufacturers. This standard requires the development of electronic and three-way catalyst technology. AMC will apparently have to purchase this technology from other manufacturers and then factor it into their product line before the company will be able to achieve compliance. For this reason, AMC may experience lead time problems substantially different from those of other domestic manufacturers.

123 Cong.Rec. at S9232 (Emphasis added). The Administrator took a similar position before the House Committee considering the bill, see 1977 House Hearings at 1683, Statement of Douglas Costle, recommending an additional year of lead time. His recommendation was endorsed by the Department of Transportation and the Federal Energy Administration in a May 19, 1977 interagency report. See “An Analysis of Alternative Motor Vehicle Emission Standards” prepared by DOT, EPA, FEA, May 19, 1977, Reprinted in 1977 House Hearings at 1693, 1702.

On June 14, 1978 the Acting Administrator of EPA granted a waiver of federal preemption to permit California’s passenger [399]

Free access — add to your briefcase to read the full text and ask questions with AI

Related

Cite This Page — Counsel Stack

Bluebook (online)
603 F.2d 978, 195 U.S. App. D.C. 396, 13 ERC 1412, Counsel Stack Legal Research, https://law.counselstack.com/opinion/american-motors-corp-v-blum-cadc-1979.